KENWOOD HDP10 Triblade Instructions

: June 3, 2024
: KENWOOD

Table of Contents

KENWOOD HDP10 Triblade
safety
key
care and cleaning
- service and customer care
troubleshooting guide
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

KENWOOD HDP10 Triblade

safety

KENWOOD-HDP10-Triblade-1

Read these instructions carefully and retain for future reference.
Remove all packaging and any labels.
If the plug or cord is damaged it must, for safety reasons, be replaced by Kenwood or an authorised Kenwood repairer in order to avoid a hazard.
Never touch the blades while the appliance is plugged in.
Keep fingers, hair, clothing and utensils away from moving parts.
Unplug after use and before changing attachments.
Never blend hot oil or fat.
Be careful if hot liquid is poured into the blending vessel/container as it can be ejected out due to sudden steaming.
For safest use it is recommended to let hot liquids cool to room temperature before blending.
Never use a damaged hand blender. Get it checked or repaired: see ‘service and customer care’.
Never let the cord touch hot surfaces or hang down where a child could grab it.
Never use an unauthorised attachment. Always switch off the appliance and disconnect from the power supply, if it is left unattended, before assembling, disassembling or cleaning.
Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved.
Misuse of your appliance can result in injury.
This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.
Children should be supervised to ensure that they do not play with the appliance.
Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.
The rated power is based on the chopper attachment. Other attachments may draw less power. important
With heavy mixtures to ensure long life of your appliance, do not use your hand blender for longer than 50 seconds in any 4 minute period.
Do not use the whisk attachment for longer than 3 minutes in any 10 minute period. chopper attachment
Do not touch the sharp blades.
Remove the chopper blade before emptying the bowl.
Never remove the cover until the chopper blade has completely stopped.
Always hold the chopper blade by the finger grip away from the cutting blades, both when handling and cleaning.

before plugging in

Make sure your electricity supply is the same as the one shown on the hand blender.
This appliance conforms to EC Regulation 1935/2004 on materials and articles intended to come into contact with food.
before using for the first time
Throw away the blade cover
from the chopper blade as it is there to protect the blade during manufacture and transit only. Take care as the blades are very sharp.
Wash all parts – see “care and cleaning”.

key

hand blender

ON button
Turbo button
power handle
blender shaft with fixed triblade.

beaker (if supplied)

beaker

A whisk (if supplied)

whisk collar
wire whisk

B chopper (if supplied)

Chopper cover
finger grip
chopper blade
bowl
rubber ring base

recommended usage chart

to use the hand blender

You can blend soups, sauces, milk shakes, mayonnaise and baby food etc. for beaker blending (if beaker supplied)
Do not fill the beaker more than 2⁄3 full.
Note
If no beaker is supplied in your pack, select a suitably sized container. We would recommend a tall, straight sided vessel with a diameter slightly larger than the foot of the hand blender to allow movement of the ingredients but tall enough to prevent splashing. for saucepan blending
For safest use it is recommended to take the pan off the heat
and let hot liquids cool to room temperature before blending.

Fit the power handle inside the blender shaft 1 and turn clockwise to lock.
Plug in.
Place the food into the beaker or a similar container, then holding the beaker steady select the required speed (select “O” ON for slower blending and to minimise slplashing and Turbo for faster blending).

To avoid splashing, place the blade in the food before switching on.
Do not let liquid get above the join between the power handle and blender shaft.
Move the blade through the food and use a mashing or stirring action to incorporate the mixture.
Your hand blender is not suitable for ice crushing.
If your blender gets blocked, unplug before clearing.
After use release the “O” ON or Turbo button. Unplug and turn the power handle anticlockwise to remove the blender shaft from the power handle.

A to use the whisk (if supplied)

You can whip light ingredients such as egg whites; cream and instant desserts.
Do not whisk heavier mixtures such as fat and sugar – you will damage the whisk.

Push the wire whisk into the whisk collar 2.
Fit the power handle to the whisk collar, turn clockwise to lock.
Place your food in a bowl.
Plug in and press the “O” ON button.
To whisk on a faster speed press the Turbo button. Move the whisk clockwise.
To reduce splashing press the “O” ON button.

Do not let liquid get above the whisk wires.
After use release the “O” ON or Turbo button, unplug and dismantle.

B to use the chopper (if supplied)

You can chop meat, vegetables, herbs, bread, biscuits and nuts.
Do not chop hard foods such as coffee beans, ice cubes, spices or chocolate – you will damage the blade.

Remove any bones and cut food into 1-2cm (1⁄2-1”) cubes.
Fit the rubber ring base bm on the bottom of the chopper bowl. (This stops the bowl sliding on the worktop.)
Fit the chopper blade over the pin in the bowl 3.
Add your food.
Fit the chopper cover, turn and lock 4.
Fit the power handle to the chopper cover 5 – turn clockwise to lock.
Plug in. Hold the bowl steady. Then press the Turbo button. Alternatively press the Turbo button in short bursts to achieve a pulsing action.
After use, unplug and dismantle.

optional attachment (not supplied in pack)
Mini chopper – refer to “service and customer care” section to order.

care and cleaning

Always switch off and unplug before cleaning.
Do not touch the sharp blades.
Some foods, e.g. carrot, may discolour the plastic. Rubbing with a cloth dipped in vegetable oil may help to remove discolouration.
Do not use abrasives. hand blender shaft either
Part fill the beaker or a similar container with warm soapy water. Plug into the power supply, then insert the hand blender shaft and switch on.
Unplug, then dry or
Wash the blades under running water, then dry thoroughly.
Never immerse in water or allow liquid inside the shaft. If water does get inside, drain and allow to dry before use.
Do not dishwash.

service and customer care

If you experience any problems with the operation of your appliance, before requesting assistance refer to the “troubleshooting guide” section in the manual or visit www.kenwoodworld.com.
Please note that your product is covered by a warranty, which complies with all legal provisions concerning any existing warranty and consumer rights in the country where the product was purchased.
If your Kenwood product malfunctions or you find any defects, please send it or bring it to an authorised KENWOOD Service Centre. To find up to date details of your nearest authorised KENWOOD Service centre visit www.kenwoodworld.com or the website specific to your Country.
Designed and engineered by Kenwood in the UK.
Made in China.

IMPORTANT INFORMATION FOR CORRECT DISPOSAL
OF THE PRODUCT IN ACCORDANCE WITH THE EUROPEAN DIRECTIVE ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE)
At the end of its working life, the product must not be disposed of as urban waste.
It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service.
Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin.

troubleshooting guide

Problem	Cause	Solution
The hand blender will not operate	No Power	Check hand blender plugged in.
Hand Blender not assembled correctly	Check attachments securely locked to

power handle.
Hand blender starts to slow or labour during processing.| Speed selected too low

Recommended operating time exceeded.

| Increase speed

Do not operate the hand blender for longer than 50 seconds in any 4 minute period for heavy mixture or the whisk

for 3 minutes in any 10

minute period.

Excessive splashing during processing| Speed selected too high.| Select a lower speed initially and increase as the mixture thickens.
| Container, bowl or pan too shallow or too small for ingredients being processed.| Select an appropriate sized container. Place the blades into the food before switching on.
Power handle gets hot during operation.| The unit may have been used for an extended period of time.| Allow the unit to cool fully before using again.
The mixture is not| The speed of the unit| Gradually increase the
blending.| may not be appropriate| speed and blend until
| for the ingredients being| desired result achieved.
| blended.|