Armacost Wireless Light Switch Remote Instruction Manual
- June 3, 2024
- Armacost
Table of Contents
Armacost Wireless Light Switch Remote
Wireless Light Switch
With wall mountable transmitter
Add switched outlet convenience without new wiring, works through walls and
doors up to 50 feet away.
OPERATION
All transmitters and receivers come pre-programmed, or “paired,” and are ready to use.
- Plug the receiver into a 120V AC electrical outlet.
- To test, plug an electrical device like a lamp into the receiver’s outlet located at the bottom of the unit. Make sure that your electrical device is powered ON.
- On the transmitter switch, push the button in the middle to turn the device ON or OFF.
Manual Override: You can manually power the unit ON/OFF by pressing the
ON/OFF override button located on the side of the Receiver. (Do not hold the
button down for manual ON/OFF operation as this will cause the unit to enter
the pairing mode.)
If you want to control multiple receivers with a single transmitter, the units
must be paired. Test the transmitter with the receivers. If the receivers do
not respond, they must be re-paired.
Pairing
- Press and hold the ON/OFF button on the receiver for 10 seconds. The LED indicator will begin to flash rapidly.
- Press the transmitter button twice. To un-pair:
- Press and hold the ON/OFF button on the receiver for 3 seconds. The LED indicator will begin to flash rapidly.
- The un-pairing procedure will un-pair all transmitters from that receiver.
Note: Each receiver can only have two transmitters paired to it at a time. Each transmitter can control up to four receivers.
TROUBLESHOOTING
The wireless switch receiver does not turn on
The remote transmitter does not work
- Make sure the battery is fresh.
- Move the transmitter closer to the receiver. Actual operational distance will vary based on walls, obstructions and other nearby electronic devices.
- Re-pair the transmitter to the receiver.
Battery replacement
Remove screws on the back of the transmitter. It uses a CR2032 battery.
SPECIFICATIONS
- Operating temperature range: 0°C (32°F) to 45°C (113°F).
- Rated: 100-250VAC, 10A
This item is a Radio Frequency Device (RF), and as such the range of the
remote control is dependent on many factors. Actual operational distance will
vary based on walls and line of sight obstructions, and other nearby
electronic devices.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
Two-year limited warranty. This product is for dry location use only. Improper
installation, improper powering, abuse, or failure to use this device for its
intended purpose will void warranty. Proof of purchase is required for all
returns. Questions?
Email support@armacostlighting.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>