MAYTAG MED7230HW 27 Inch Electric Smart Dryer User Guide

MED7230HW 27 Inch Electric Smart Dryer
User Guide

MED7230HW 27 Inch Electric Smart Dryer

WARNING:
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly could result in serious injury, death, or property damage.

• Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

• WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.
  • Do not touch any electrical switch; do not use any phone in your building.
  • Clear the room, building, or area of all occupants.
  • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
  • If you cannot reach your gas supplier, call the fire department.

• Installation and service must be performed by a qualified installer, service agency, or the gas supplier.

WARNING: Gas leaks cannot always be detected by smell.
Gas suppliers recommend that you use a gas detector approved by UL or CSA.
For more information, contact your gas supplier.
If a gas leak is detected, follow the “What to do if you smell gas” instructions.

IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electric shock, or injury to persons when using the dryer, follow basic precautions, including the following:

• Read all instructions before using the dryer.

• Do not place items exposed to cooking oils in your dryer. Items contaminated with cooking oils may contribute to a chemical reaction that could cause a load to catch  fire.

• To reduce the risk of fire due to contaminated loads, the final part of a tumble dryer cycle occurs without heat (cool down period). Avoid stopping a tumble dryer before  the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated.

• Do not dry articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, dry­ cleaning solvents, or other flammable or explosive substances  as they give off vapors that could ignite or explode.

• Do not allow children to play on or in the dryer. Close supervision of children is necessary when the dryer is used near children.

• Before the dryer is removed from service or discarded, remove the door to the drying compartment.

• Do not reach into the dryer if the drum is moving.

• Do not install or store the dryer where it will be exposed to the weather.

• Do not tamper with controls.

• Do not repair or replace any part of the dryer or attempt any servicing unless specifically recommended in this
  Use and Care Guide or in published user­repair instructions that you understand and have the skills to carry out.

• Do not use fabric softeners or products to eliminate static unless recommended by the manufacturer of the fabric softener or product.

• Do not use heat to dry articles containing foam rubber or similarly textured rubber­like materials.

• Clean lint screen before or after each load.

• Keep area around the exhaust opening and adjacent surrounding areas free from the accumulation of lint, dust, and dirt.

• The interior of the dryer and exhaust vent should be cleaned periodically by qualified service personnel.

• See Installation Instructions for grounding instructions.

CONTROL PANEL AND FEATURES

1. POWER
   Touch to turn on/off or to stop/cancel a cycle.

2. CYCLE KNOB
   Turn knob to select desired cycle.
   EXTRA POWER
   Press to boost drying power on any drying cycle by adding extending time, heat, and tumbling.

3. DISPLAY LCD
   Display LCD will show the cycle settings and estimated time remaining. Adding or changing default options will also affect time shown in display.

4. START/PAUSE
   Touch and hold; cycle will start after countdown.
   Touch START/PAUSE during a cycle to pause it. Touch again to resume.

5. CYCLE MODIFIERS (Not all modifiers are available on all cycles. See cycle guide for more information.)
   NOTE: Dryer remembers the last completed cycle and cycle settings. The next time you turn dryer on, it will be set to run the last cycle.
   TEMP
   Touch to modify the cycle’s available temperatures. (Air Only, Low, Medium, Medium High, High).
   DRYNESS
   Touch to modify the cycle’s available dry levels on the sensor cycles (Less, Normal, More).
   WRINKLE PREVENT
   Touch to turn on/off and on with steam (select models). Wrinkle Prevent adds up to 150 minutes of periodic tumbling and heat to help reduce wrinkling. Wrinkle  Prevent with Steam will add a short steam cycle after 60 minutes to help smooth wrinkles.

6. CYCLE OPTIONS (Not all options are available on all cycles).
   DRUM LIGHT
   Touch to turn the drum light on/off.
   REMOTE ENABLE
   Touch each time you want to remotely control via the Maytag™ app. Follow the instructions in the “GET THE MAYTAG™ APP AND GET CONNECTED” section below for more details.
   NOTE: Once Remote Enable has been selected, certain interactions with the dryer will cause it to cancel Remote Enable.
   Example: Opening the door.

STEAM OPTIONS
Touch to add Steam or Reduce Static to selected cycle. Steam adds steam to the end of certain Sensor Cycle to help smooth wrinkles. Reduce Static will automatically tumble,  pause, and introduce a small amount of moisture to the load to help reduce static.
MORE TIME (Timed Dry & Quick Dry only)
Touch to increase the length of a Timed Dry or Quick Dry Cycle.
LESS TIME (Timed Dry & Quick Dry only)
Touch to decrease the length of a Timed Dry or Quick Dry Cycle.
CYCLE SIGNAL
Use this option to turn the signal indicating the end of a drying cycle to Low, Medium, High, or Off.
NOTE: Press/hold CYCLE SIGNAL to select the volume.
DAMP DRY SIGNAL
Touch DAMP DRY SIGNAL or touch and hold CYCLE SIGNAL (depending on the model) for at least 3 seconds to turn the Damp Dry Signal on or off. User will get a sound and display notification telling them “Items are damp. You can pause and reposition for best results”.
CHECK VENT
The Check Vent alert is a feature available for Automatic cycles only. This alert will show the status of airflow through the dryer and the dryer vent system for the dryer’s life.  During the sensing phase at the beginning of the cycle if it detects a blocked vent or low pressure it will display “Check vent. Clean lint screen or vent for better  performance.”
REMEMBER: The dryer will continue to operate even when check vent notification is displayed, but poor airflow can impact dry times and overall performance.
Display message can be cleared by pressing any key with the exception of Power which will cancel the cycle.

GET THE MAYTAG™ APP AND GET CONNECTED

With your mobile device download the Maytag™ app. You can get subscription and connectivity instructions, terms or use, and privacy policy at www.maytag.com/connect  or in Canada www.maytag.ca/connect.

Once installed, launch the app and you will be guided through the steps to subscribe and create your user account to connect to your appliance. If you have any problems or  questions, call Maytag®
Connected Appliances at 1-866-333-4591.
When unit is first powered on, it will prompt to select language before they see message to Download APP or press any other key to setup WiFi later.

USING YOUR DRYER
WARNING

Fire Hazard
No washer can completely remove oil.
Do not dry anything that has ever had any type of oil on it (including cooking oils).
Items containing foam, rubber, or plastic must be dried on a clothesline or by using an Air Cycle.
Failure to follow these instructions can result in death or fire.

WARNING

Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from dryer.
Do not dry anything that has ever had anything flammable on it (even after washing).
Failure to follow these instructions can result in death, explosion, or fire.

If you accidentally select wrong language during digital un-boxing and/or you want to get back to Factory settings then perform Factory Reset.
FACTORY RESET
Press/hold both TEMP and WRINKLE PREVENT keys until display count-down has completed. Unit will power back on with “Select Language” display message.
*NOTE: See “Cycle Guide” for more information about cycles, settings, and options. Not all cycles, settings, and options are available with all models. Read all your Manuals  for more information on your unit.

BOOST DRYING POWER ON SELECTED CYCLE

EXTRA POWER Option

• Press the knob to select EXTRA POWER.

• Extra Power is active if the cycle control knob is illuminated.
  If activated after starting a cycle, additional time may not be automatically added.

• Press to boost drying power on any drying cycle by adding extending time, heat, and tumbling.

CYCLE GUIDE
(Use sensor cycles for better fabric care and energy savings.)
The dryer senses moisture in the load or air temperature and shuts off when the load reaches the selected dryness level. The exact cycle times will vary, depending on load size and type.
Settings shown are default settings for that cycle. Once you select a cycle, the default modifiers or the previous set modifiers for that cycle will be shown in the Display LCD.  For best fabric care, choose the cycle that best fits the load being dried. Not all cycles and options are available on all models. Please refer to garment label instructions for best care.

CYCLE GUIDE – MANUAL CYCLES

TIMED DRY – It will run the dryer for the specified time on the control. Not all cycles and options are available on all models.

CYCLE GUIDE – STEAM REFRESH CYCLES (Steam models only) Not all cycles and options are available on all models.

Load Size Recommendations
For best results, follow the load size recommendations noted for each cycle.
Small load: Fill the dryer drum with 3–4 items, not more than 1/4 full.
Medium load: Fill the dryer drum up to about 1/2 full.
Large load: Fill the dryer drum up to about 3/4 full.
Do not pack tightly. Items need to tumble freely.

NOTE: These clothes dryer’s Government energy certifications were based on the Normal Cycle, Maximum Drying Temperature Setting, Normal Dryness Level, Eco  Strategy ON. The as – shipped defaults of Wrinkle Prevent off, Remote Enable off, Eco Strategy ON, were used.
Models 6230
NOTE: These clothes dryer’s Government energy certifications were based on the Timed Dry Cycle, and Maximum Drying Temperature Setting. The as – shipped defaults  of Wrinkle Prevent off, Remote Enable off, Normal Dryness Level, Eco Strategy ON, were used.
Cycles that are available for post-sale download may use more energy than the Normal cycle, upon which the energy use rating of this dryer is based.

DRYER ICONS

ASSISTANCE OR SERVICE AND ADDITIONAL INFORMATION

For detailed installation instructions and maintenance information, winter storage and transportation, please see the INSTALLATION AND CARE INSTRUCTIONS MANUAL included with your machine.
For information on any of the following items, the full cycle guide, warranty, detailed product dimensions, or for complete instructions for use and installation, please visit www.maytag.com/owners or in Canada www.maytag.ca/owners.
For information on any of the following items please visit www.maytag.com/owners or in Canada www.maytag.ca/owners.
This may save you the cost of a service call.

To speak with a customer service representative or if you have additional questions, call us toll free at
1-800-344-1274 or in Canada call 1-800-688-2002.
You can write with any questions or concerns at:

Maytag Brand Appliances
Customer eXperience Center
533 Benson Road
Benton Harbor, MI 49022-2692
Maytag Brand Appliances
Customer eXperience Center
Unit 200-6750 Century Ave
Mississauga, Ontario L5N 0B7
Please include a daytime phone number in your correspondence.
®/™ ©2021 Maytag. All rights reserved. Used under license in Canada.

References

• connect | Maytag
• Service & Support Owners Center | Maytag
• How to Connect Your Smart Appliance | Maytag
• Service & Support Owners Center | Maytag

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>