CONDUCTIX wampfler Line Feed SingleFlexLine Program 0815 Instruction Manual
- June 3, 2024
- Conductix Wampfler
Table of Contents
Installation Instructions
Line Feed
SingleFlexLine Program 0815
Technical Data
- For straight and bended rails r ≥ 1000 mm
- Imax = 54 A
- Cable Cross Section = 4-6 mm²
Installation
Work steps:
-
Bend the rail to the desired radius (see BAL0800-0004).
-
Cut the insulation profile on the needed position.
-
Put the U-plate on the right position and drill a hole with Ø = 3.1 mm (one hole on each side with a staggered arrangement).
Notice: The holes (1) for the blind rivets are no through holes!
-
Put a blind rivet at each side, notice a staggered arrangement.
-
Crimp the cable and cable lug.
-
Consider the required arrangement of small parts and fix it with the hexagon nut. Tighten the screw with 2 Nm.
All parts included in delivery!
| Pos. | Description |
|---|---|
| 1 | Contact Plate Line Feed 0815 |
| 2 | Blind Rivet Copper/Bronze Ø3×5 Flat Head |
| 3 | Cable Lug M4/6mm² |
| 4 | Detent-Edged Washer SHB-K-D4,1-A4 |
| 5 | Hexagon Nut DIN934-M4-A4 |
| 6 | Power Feed Cover 0815 SP |
-
After the assembly it should be like following:
-
After the cable was connected, put the feed cap over the feeding point and consider the direction for the cable.
-
Installation position (feed offset): Mount the power feeds with an offset
-
Do not mount the power feeds directly next to the hanger clamp.
Conductix-Wampfler GmbH
Rheinstraße 27 + 33
79576 Weil am Rhein – Märkt
Germany| Phone: +49 (0) 7621 662-0
Fax: +49 (0) 7621 662-144
[email protected]
www.conductix.com
---|---
Importer for the United Kingdom:
Conductix-Wampfler Ltd.
1, Michigan Avenue
Salford
M50 2GY
United Kingdom| Phone: +44 161 8480161
Fax: +44 161 8737017
[email protected]
www.conductix.com
Order Number: 08-E015-0570
MV0815-0009b-EN
www.conductix.com
original document
Documents / Resources
|
CONDUCTIX wampfler Line Feed SingleFlexLine Program
0815
[pdf] Instruction Manual
Line Feed SingleFlexLine Program 0815, Line Feed, SingleFlexLine Program 0815,
SingleFlexLine, SingleFlexLine Program, Program 0815
---|---