Simply45 S45-1100 Unshielded Standard WE-SS 8P8C RJ45 Modular Instructions

June 3, 2024
Simply45

Best Practice Termination Instructions

S45-1100 Unshielded Standard WE-SS 8P8C RJ45 Modular

  1. Bar45® uses a Hi/Lo stagger design and is made of a material that provides better signal isolation improving NEXT performance;
  2. On S45-1100, the Bar45® is located over the RJ45 pins. This allows the LAN cable to be inserted deeper into the Plug. This reduces the length of untwisted wires improving signal integrity and negating crosstalk interference.

For improved termination performance, please follow the step-by-step instructions for terminating the S45-1100 RJ45 modular plugs.
Simply45 S45-1100 Unshielded Standard WE-SS 8P8C RJ45 Modular - fig
1Simply45 S45-1100
Unshielded Standard WE-SS 8P8C RJ45 Modular - fig 2 STEP 1
If using Cat6 UTP cable, trim center spline/pair separator as close to the cable jacket as possible without nicking any of the wire conductors.

Simply45 S45-1100 Unshielded Standard WE-SS 8P8C RJ45 Modular - fig
3

STEP 2
Make sure each wire conductor is straight. We recommend using the Simply45 Adjustable LAN Cable Stripper (Part: S45-SO1BL/YL) that has a wire straightener comb on the top.

Simply45 S45-1100 Unshielded Standard WE-SS 8P8C RJ45 Modular - fig
4

STEP 3
Then straighten and align wires to correct alignment pattern (Type A or B). The B Pattern is most commonly used today. Using angled flush cutter tool (such as Simply45 part: S45-801), trim wire ends straight before inserting into the load bar.

Simply45 S45-1100 Unshielded Standard WE-SS 8P8C RJ45 Modular - fig
5

STEP 4
Insert the Pattern Aligned wires asshown above (B pattern shown)

WIRING CHART

Simply45 S45-1100 Unshielded Standard WE-SS 8P8C RJ45 Modular - fig
7

STEP 5
Slide Bar45® down until it touches or comes close to the cable jacket.

Simply45 S45-1100 Unshielded Standard WE-SS 8P8C RJ45 Modular - fig
8

STEP 6
Then trim wires flush with the load bar using the Angled Flush Cutter (part: $45-801
(https://simply45.com/shop/tools/cutters/s45-801-simply45-premium-5-flush- cutter-tool/)). Please be sure to trim wires properly. If wires are not trimmed close to the load bar, the load bar will not set properly over the Plug pins.

Simply45 S45-1100 Unshielded Standard WE-SS 8P8C RJ45 Modular - fig
9

STEP 7
Insert the cable with the Bar45@ into the plug with the load bar over the pins. (fig. 1). Notice in the picture (fig. 2) that the cable jacket should come to the horizontal line underneath the plug (S45- 1100).

Simply45 S45-1100 Unshielded Standard WE-SS 8P8C RJ45 Modular - fig
10

STEP 8
Insert the loaded plug into the Simply45 Crimper socket. Be sure that plug is fully inserted. Then complete crimping cycle.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals