Dimplex Optiflame Stove Fire Instruction Manual
- June 3, 2024
- Dimplex
Table of Contents
Dimplex Optiflame Stove Fire Instruction Manual
CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/OR DAMAGE AND MAY INVALIDATE YOUR GUARANTEE
Important Safety Advice
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock and injury to persons, including the following:
- If the appliance is damaged, check with the supplier before installation and operation.
- Do not use outdoors.
- Do not use in the immediate surroundings of a bath, shower or swimming pool.
- Do not locate the appliance immediately below a fixed socket outlet or connection box.
- Do not use this heater if it has been dropped.
- Do not use if there are visibe signs of damage to the heater.
- Use this heater on a horizontal and stable surface, or fix it to the wall, as applicable
Warning : This heater must not be used for anything other than normal domestic household purposes in the country where it was purchased from a recognised commercial retailer.
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge as long as they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be undertaken by children without supervision.
Children of less than 3 years should be kept away from the appliance unless
continuously supervised. Children aged from 3 years and less than 8 years
shall only switch on/off the appliance, provided that it has been placed or
installed in its intended normal operating position and they have been given
supervision or instruction concerning use of the appliance in a safe way and
understanding the hazards involved. Children aged from 3 years and less than 8
years shall not plug in, regulate and clean the appliance or perform user
maintenance.
Do not use this appliance in series with a thermal control, a program
controller, a timer or any other device that switches on the heat
automatically, since a fire risk exists when the appliance is accidentally
covered or displaced.
Although this appliance complies with safety standards, we do not recommend
its use on deep pile carpets or the long hair type of rugs.
In the event of a fault, unplug the appliance. Unplug the appliance when not
required for long periods.
The appliance must be positioned so that the plug is accessible. If the supply
cord is damaged it must be replaced by the manufacturer or service agent or a
similarly qualified person in order to avoid a hazard. Keep the supply cord
away from the front of the appliance.
Warning : Do not use this heater in small rooms when they are occupied by
persons not capable of leaving the room on their own, unless constant
supervision is provided.
Warning : To reduce the risk of fire, keep textiles, curtains, or any
other flammable material a minimum distance of 1m from the air outlet.
Caution : Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present. This instruction can be found at www.dimplex.co.uk
Warning : In order to avoid overheating, do not cover the heater. Do not place material or garments on the appliance, or obstruct the air circulation around the appliance, for instance by curtains or furniture, as this could cause overheating and a fire risk.
The appliance carries a Do Not Cover label or the Warning Symbol shown here on the right. This symbol indicates that it must not be covered. Do not cover or obstruct the heat outlet grill in any way. This is located above the flame window on the appliance.
Warning : In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
WARNING: KEEP BATTERIES OUT OF REACH OF CHILDREN
- Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical burns and potential perforation of the oesophagus.
- If you think batteries might have been swallowed or placed inside any part of the body seek immediate medical attention
- Examine devices and make sure the battery compartment is correctly secured, e.g. that the screw or other mechanical fastener is tightened. Do not use if the compartment is not secure.
- Dispose of used button batteries immediately and safely. Flat batteries can still be dangerous.
CAUTION: No obvious symptoms
Unfortunately, it is not obvious when a button or coin battery is stuck in a child’s oesophagus (food pipe).
There are no specific symptoms associated with this. The child might:
- cough, gag or drool a lot;
- appear to have a stomach upset or a virus;
- be sick;
- point to their throat or stomach;
- have a pain in their abdomen, chest or throat;
- be tired or lethargic;
- be quieter or more clingy than usual or otherwise “not themselves”;
- lose their appetite or have a reduced appetite; and
- not want to eat solid food/be unable to eat solid food.
These sorts of symptoms vary or fluctuate, with the pain increasing and then subsiding.
A specific symptom to button and coin battery ingestion is vomiting fresh (bright red) blood. If the child does this seek immediate medical help.
The lack of clear symptoms is why it is important to be vigilant with “flat” or spare button or coin batteries in the home and the products that contain them.
Dimplex Optiflame Stove Fire
Models: BFD20, BFD20E, BFD20PB, SBN20, SBN20E, BFD20BRG, BFD20SL, BAR20
Thank you for choosing a Dimplex electric fire.
General Information
Unpack the heater carefully and retain the packaging for possible future use,
in the event of moving or returning the fire to your supplier.
These models are designed to be free standing and are normally positioned
against a wall.
The fire incorporates a flame effect, which can be used with or without
heating, so that the comforting effect may be enjoyed at any time of the year.
Using the flame effect on its own only requires little electricity.
A choice of 1kW or 2kW heat output is provided by the fan heater, which is
located at the bottom of the unit.
Before connecting the heater check that the supply voltage is the same as that
stated on the heater.
Please note: Used in an environment where background noise is very low,
it may be possible to hear a sound which is related to the operation of the
flame effect. This is normal and should not be a cause for concern.
Technical Information
Model No: BFD20, BFD20E, BFD20PB, SBN20, SBN20E, BFD20BRG, BFD20SL, BAR20
with mechanic thermostat room temperature control.
Electrical connection
WARNING – THIS APPLIANCE MUST BE EARTHED.
This heater must be used on an AC ~ supply only and the voltage marked on the heater must correspond to the supply voltage. Before switching on, please read the safety warnings and operating instructions.
Operating The Product
Controls – see Fig. 2
These switches provide a choice of heat settings, The appliance is in standby mode when the mainslead is plugged in. This is indicated by the red neon behind the flame effect screen. The two selector switches are in the ON position when the side with the markings on (i.e. I, or II) is pushed in.
Selector switch 1 ( )
Controls the electricity supply to the appliance and flame effect. Press for ‘ON’ and ‘Standby’. If both selector switches 2 and 3 are in the OFF position, the product works on flame effect only.
Selector Switch 2 (I)
Provides 1kW heat output
Selector Switch 3 (II)
Provides 2kW output with switch 2
Thermostat (T) – see Fig. 4
In order to maintain a certain room temperature, set the controller to ‘max.’. Operate the appliance at full power until the required room temperature is reached. Set back the thermostatic controller until the appliance switches off with an audible “click”. This temperature will be kept almost constant by the thermostatic control switching on and off automatically. Please note that the appliance can only be switched on when the thermostat setting is higher then the room temperature.
Remote control – see Fig. 3
The maximum range of use is ~ 5metres.
Warning: It takes time for the receiver to respond to the transmitter.
Do not press the buttons more than once within two seconds for correct
operation.
Battery information – see Fig. 3
- To activate the remote control remove the battery isolation strip, which is used to ensure your remote control reaches you fully charged.
- Remove the screw, follow the instruction on the back of the remote to release the battery housing. Slide the battery cover open. Install Lithium battery in the battery holder. The positive (+) side of the battery faces up. Close the battery cover and replace the screw
- Only use CR2025 or CR2032 size of batteries.
Discard leaking batteries
Dispose of batteries in the proper manner according to provincial and local
regulations.
Any battery may leak electrolyte if mixed with a different battery type, if
inserted incorrectly, if all the batteries are not replaced at the same time,
if disposed of in a fire, or if an attempt is made to charge a battery not
intended to be recharged.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE HEATER.
Cleaning
Before commencing cleaning, unplug the heater and allow it to cool. For
general cleaning use a soft clean duster – never use abrasive cleaners. The
glass viewing screen should be cleaned carefully with a soft cloth. DO NOT use
proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush attachment of a
vacuum cleaner should occasionally be used to clean the outlet grille of the
fan heater.
Light Emitting Diode
This fire is fitted with LED (Light Emitting Diode) lamps. These LED lamps are maintenance-free and should not require replacing during the life of the product.
CAUTION : Assembly, installation and repair of this heater must be carried out by Dimplex or its authorised agent.
Thermal Safety Cut-out
The built-in overheat cut-out switches off the appliance automatically in the event of a fault. If this occurs switch off the appliance or disconnect the mains plug from the socket. After a short cooling down phase, the appliance is ready for use again. If the fault should occur again, see your local dealer.
Additional Information
Recycling
At the end of the electrical products useful life it not be disposed of with
household waste.
Please recycle where facilities exist. Check with your Local Authority or
retailer for recycling advice in your country.
After Sales Service
Your product is guaranteed for one year from the date of purchase. Within this period, we undertake to repair or exchange this product free of charge provided it has been installed and operated in accordance with these instructions. Your rights under this guarantee are additional to your statutory rights, which in turn are not affected by this guarantee.
CAUTION : Do not use if the heater’s mains power lead is damaged. Such
use may cause a hazard.
If damaged, the mains power lead must be replaced by the manufacturer or its
authorised dealer.
Should you require after sales information or assistance with this product please go to www.dimplex.co.uk where you will find our self help guide by clicking our “After Sales” or ring our help desk on 0344 879 3588 (UK) or 01 842 8222 (R. O. I.). Spare parts are also available on the web site. Please retain your receipt as proof of purchase.
Tel: 0344 879 3588
Republic of Ireland Tel: 01 8428 222
www.dimplex.co.uk
Dimplex Millbrook House, Grange Drive, Hedge End, Southampton, SO30 2DF
© Glen Dimplex Heating and Ventilation.
All rights reserved. Material contained in this publication may not be
reproduced in whole or in part, without prior permission in writing of Glen
Dimplex Heating and Ventilation.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>