Dimplex RBF24TRIM36 Revillusion 30 Built In Firebox Instruction Manual
- May 15, 2024
- Dimplex
Table of Contents
Dimplex RBF24TRIM36 Revillusion 30 Built In Firebox
Hardware
The trim allows for several installation methods. Please read the entire
instruction booklet to determine which option is your preferred installation
method?
In keeping with our policy of continuous product development, we reserve the
right to make changes without notice.
Assembly Instructions
-
The trim is pre-assembled from the factory with an optional bottom trim. If the firebox will be installed in an elevated location, the bottom trim will be required. If the firebox will be installed on the floor, remove the bottom trim. To remove the bottom trim remove eight (8) screws as shown.
**1**
-
Prior to installing the trim, remove inner decorative panels from the fireplace by tilting the top inwards, then pull up and out.
**2**
-
Installation Option – If installing into an existing opening, screw the fireplace to the trim, using the four (4) provided screws. Push the trim and fireplace into the final installed location. Go to Step 4.
**3A**
-
Installation Option – If installing into a new construction, screw the fireplace and trim to the wall. Using a ¼” or 6mm drill bit, drill out the existing holes in the trim. Slide the trim over the fireplace and using a suitable screw attach to framing. Go to Step 4.
**3B**
- Re-install the inner decorative panel by sliding the bottom in first, then tilt to top in place.
**4**
**5**
CUSTOMER SUPPORT
1-888-346-7539 |
www.dimplex.com
In keeping with our policy of continuous product improvement, we reserve the
right to make changes without notice.
© 2018 Glen Dimplex Americas
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>