DYNAVIN D8-MST2015L/H Android Car Radio Connections Installation Guide
- June 3, 2024
- DYNAVIN
Table of Contents
DYNAVIN D8-MST2015L/H Android Car Radio Connections
Wire Connections
(XM) Sirius XM Adapter Cable: For use only when installing the Sirius XM
SXV300 tuner for built-in satellite radio.
(ANT) Bluetooth/WiFi Antenna with extension cable: Thread the copper-
colored BT/WiFi Antenna extension cable into the back of the Dynamin. On the
other end, thread the BT/WiFi Antenna then run it under the center console
near the parking brake for best receptivity. DO NOT position it behind the
Dynamin.
( GPS) GPS Antenna: Is magnetic so can be mounted inside the dash on top
of anything metal positioned forward in the dash. If reception is not
adequate, can be mounted on the inside corner of the windshield or anywhere
with good reception.
(RADIO) AM/FM Radio: Plug in the factory radio tuner plug here.
(CAM) Camera RCA Harness: For use with the factory camera adapter or any
aftermarket camera. The brown RCA labeled “CAMERA” is plugged into the brown
RCA on the factory camera adapter. Use version “A” or “B” depending on which
one fits. If both fit, see which one shows the reverse picture when in reverse
and use that one. (The other one will show a blank screen.)
(MIC) Microphone: Must be installed for Bluetooth calling and voice
command functionality. Can be mounted on the steering wheel column, a pillar,
or above the rearview mirror. Test before finishing the install.
(AUX) Factory Auxiliary Integration: If your car is equipped with an
auxiliary plug, you will plug in these RCAs from the MWH (main wire harness).
(MWH) Main Wire Harness: The black end plugs into your car’s factory
plug. Other RCAs: The other red and white RCAs are used with an aftermarket
amp only. The red RCA is for an aftermarket sub. The yellow RCA is typically
used for a front camera.
The remaining plugs are not currently used.
INCLUDED PARTS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>