LEITZ SHREDDERS IQ Slim Home Office P4, Office S P4 Instruction Manual

: June 3, 2024
: LEITZ

Table of Contents

Specifications
Overview
Operation
**** Warning symbols
CAN shred the following:
CANNOT shred the following
****
Bin full
Troubleshooting
Waste Electrical and Electronic Equipment (WEEE)
Guarantee
Customers Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LEITZ SHREDDERS IQ Slim Home Office P4, Office S P4 Instruction Manual

Specifications

Using Instruction

Overview

Indicator panel
Shredder head with handles
Bin viewing window
Safety symbols
Paper feed slot
On/Off switch

Please read and keep these Important safety instructions

**** For a full copy of the operating instructions, hints & tips and troubleshooting guide, please visit www.leitz.com

** The following symbol which is found on the product indicates you could be seriously hurt or killed if you open the machine.
DO NOT OPEN.**

WARNING
Electrical shock hazard. Do not open. No user serviceable parts inside. Refer servicing to qualified service personnel.

Only use the unit for its intended purpose.
The unit must only be connected to a supply voltage corresponding to the electrical rating shown on the unit.
Unit should be connected to a socket outlet near the equipment that is easily accessible.
Do not connect multiple adaptors or use with an extension cable.
Failure to follow these instructions could result in damage/injury and will invalidate your guarantee.
Do not attempt to service or repair the unit yourself.
If recycling, separate paper and credit card shreds.
Do not use this unit if the cable or plug have been damaged.
Care should be taken when moving equipment to avoid any unleveled surfaces.
Please read all the safety information and the instructions. The manufacturer is not liable for cases of material damage or personal injury caused by incorrect handling or non compliance with the safety instructions. In such cases, the warranty will be voided.
The device is intended for use indoors. Never use outdoors.
Keep the device away from moisture.
Be vigilant at all times, and always be careful what you are doing. Do not use electrical equipment if you are lacking in concentration or awareness, or are under the influence of drugs, alcohol or medication. Even a moment of inattentiveness can lead to serious accidents and injuries when using electrical equipment.
Do not attempt to open, modify or repair the device. Do not drop, puncture, break or expose to high pressure.
Alterations to the device and technical modifications are not permitted.
Check the device and cable (and if applicable, the adapter) for any damage before use. If there is any visible damage, a strong odour, or excessive overheating of components, unplug all the components immediately and stop using the device.
Shredder must be disconnected from power source, if not used for an extended period of time.
Do not use spray cleaners or spray lubricants as these may present a risk of flash fire.

Warning:
Sharp edges, do NOT touch cutters
Warning:
Moving parts, do NOT touch cutters

Never bypass the safety interlock (strictly forbidden & dangerous, especially when unit is connected to a power source)

Indicator Panel	Icon	Color
Power On BUTTON		White
Reserve BUTTON
Shredding in operation INDICATOR		Blue
Cooling Down INDICATOR		Red
Auto reverse indicator		Red

Operation

Remove shredder from packaging and place shredder head on top of the bin.
Connect shredder to an appropriate mains supply. Ensure the on/off switch is in the On position. The blue shredder in operation icon will flash every 3 seconds.
To commence shredding press and release the button. The flashing icon changes to a solid blue light.
You are now able to shred.
Insert paper to be shredded into the feed slot ‘e’. While paper is being shredded the blue shredder in operation icon will remain illuminated.
Note: Make sure the paper to be inserted is neatly stacked.
If the paper thickness is within the shredder’s capacity, the motor will start and your documents will be shredded. The cutters will stop once the shredding process is complete.
If the paper thickness is greater than the shredder’s capacity the auto reverse icon will flash red and the motor will run in reverse.
If this happens, remove some of the sheets from the paper stack and re-try. The shredder will automatically start and allow the paper to be shredded.

Warning: Do NOT under any circumstances use any metal objects (scissors, letter openers etc.) in an attempt to clear the paper entry

**** Warning symbols

No CDs
Keep loose jeweler clear
No credit card
Ties and loose clothing hazard
Keep long hair clear
Do not reach into opening
This equipment is not intended for use by children
Manual feed slot capacity
No aerosols

Rare occasions of jamming
Should the paper jam not clear, press and hold the button for 2 seconds, then press and hold the button for 2 seconds.
Repeat until the jam has cleared. Please do not alternate between the Reverse and Forward functions quickly as this may damage the motor.

Reverse function

Should you wish to reverse the shredding direction whilst shredding a document a reverse function has been fitted for your convenience.
By pressing and holding the reverse button the cutters will change direction allowing the retrieval of the document being shredded.
The reverse function will only run whilst is being pressed. When the reverse button has been released the shredder will revert to ready mode.

Operation time
When the shredder is used continuously for 6 minutes or more the shredder may overheat. If this occurs the overheat icon will illuminate red.
When the shredder is ready to be used again the red overheat icon will go out. This will take approx. 60 minutes.
To resume shredding, press the On button and start feeding documents into the feed slot.

Quiet shredding
This shredder has been designed with quiet shredding technology. This allow you to shred with peace of mind you will not disturb others.

CAN shred the following:

IQ Slim Home Office P4: 10 sheets
Stapled paper, 25mm within the corner
26/6 and 24/6 or smaller staples
Small sized paper
IQ Slim Home Office P4: 10 sheets
Paperclipped paper, 25mm within the corner
Capable of shredding small/medium paperclips (max. wire thickness = 0.9 mm)
80/100gsm paper
Thick paper or card <200gsm
Glossy paper or a sheet covered with print on both sides.
Multiple folded sheets (A3 sheets folded in half).

CANNOT shred the following

Heavy duty staples. Check the staple leg length is not greater than 6mm.
Large clips. Check the length of the paperclip is not longer than 32mm.
Plastic sheets, laminated documents, plastic folders.
Bulldog clips
Bound documents
Credit cards
Adhesive labels.
Magazines or other documents bound by multiple staples or clips.

****

No aerosols
No oil
CDs & DVDs

Bin full

When the bin is full the shredder head will be pushed up off the bin.
This will stop the shredder from shredding.
Please empty the bin and then position the shredder head back on top of the bin.
You can now start shredding.

WARNING
The shredder bin must be fully pushed closed for the machine to operate.

Empty the shredder bin when it is full otherwise the shredder’s performance will be adversely affected.
Operating the shredder with a full shredder bin can result in paper jamming in the cutters, which will
increase the machine’s noise level.
Do not force down shredded paper in the bin using your feet.

Troubleshooting

If the paper shredder will not start, please check the following:

Is the machine plugged in correctly?
Is the switch pushed to the position?
Is the machine jammed with paper?
Has the motor overheated?

Waste Electrical and Electronic Equipment (WEEE)

Electrical and electronic devices contain materials and substances that can have damaging effects on human health and the environment. This symbol indicates that this device must not be treated as unsorted municipal waste but must be collected separately. Dispose of the device via a collection point for the recycling of waste electrical and electronic equipment within the EU, UK and in other European countries that operate separate collection systems for waste electrical and electronic equipment. By disposing of the device in the proper anner, you help to avoid possible hazards for the environment and public health that could otherwise be caused by improper treatment of waste equipment. The recycling of materials contributes to the conservation of natural resources.

Guarantee

Operation of this machine is guaranteed for two years within the date of purchase, subject to normal use. Within the guarantee period, ACCO Brands Europe will at its own discretion either repair of replace the defective machine free of charge. Defects due to misuse or use for inappropriate purposes are not covered underthe guarantee.
Proof of date of purchase will be required. Repairs or alterations made by persons not authorised by ACCO Brands Europe will invalidate the guarantee. It is our aim to ensure that our products perform to the specifications stated. This guarantee does not affect the legal rights which consumers have under applicable national legislation governing sale of goods. This guarantee does not apply to Australian customers – see
warranty on page 104.