ITALERI 6433 Road 6 Heavy Recon Armored Car Instruction Manual
- June 4, 2024
- ITALERI
Table of Contents
ITALERI 6433 Road 6 Heavy Recon Armored Car
The heavy armored car Sd. Kfz. 232 (Schwere Panzerspähwagen 232) was deployed by Wehrmacht units in the mid-thirties. The effective management of reconnaissance and radio communications between units was an essential feature of rapidly moving military operations known as “blitzkrieg”. The armored car Sd.Kfz. 232 was a key component in meeting this need. The mobility of the six- wheeled vehicle, both on and off-road, was complemented by enhanced radio communications equipment which was equally effective over both short and long range. The armored car was fitted with a voluminous antenna frame which was then later replaced with a vertical antenna that ensured effective battlefield communications between commanders and troops. The turret armament provided sufficient firepower for both vehicle defence and on advanced reconnaissance missions.
WARNING: Model for adult modellers age 14 and over
ATTENTION – Useful advice!
- Study The inSTrUcTionS carefULLy Prior To aSSembLy. remove ParTS from frame wiTh a SharP Knife or a Pair of SciSSor and Trim away exceSS PLaSTic. do noT PULL oL ParTS. aSSembLe
- The ParTS in nUmericaL SeqUence. USe PLaSTLc cemenT onLy and USe cemenT SParingLy To avoid damaging The modeL. bLacK arrowS indicaTe ParTS To be gLUed TogeTher. whiTe arrowS indicaTe on which frame The ParTS mUST be aSSembLed wiThoUT USing cemenT. TheSe LeTTerS (a – b – c…) indicaTe on which frame The ParTS wiLL be foUnd. PainT SmaLL ParTS before deTaching Them from frame. remove PainT where ParTS are To be cemenTed. croSSed oUT ParTS mUST noT be USed.
PRODUCT INSTRUCTIONS
-
A Flat White
F.S. 37875
Italeri AcrylicPaint – 4769AP -
B Flat Black
F.S. 37038
Italeri AcrylicPaint – 4768AP -
C Flat Wood
F.S. 30257
Italeri AcrylicPaint – 4673AP -
D Flat Gun Metal
F.S. 37200
Italeri AcrylicPaint – 4681AP -
E Flat Rust
F.S. 30109
Italeri AcrylicPaint – 4675AP -
F Metal Gloss Silver
F.S. 17178
Italeri AcrylicPaint – 4678AP
- Parts not for use
- Drill holes
INSTALLATION
Direction for applying the decals: cut the required decals out of the
sheet: dip the into a glass of clean water for about 20; position the decals
on the kit, letting them slide from the paper. For a better adesion, press
them by means of a clean rag.
PRODUCT VERSIONS
- VERSION A: GERMAN ARMY, 2nd PANZER DIvVIsION FRANCE, 1940.
- VERSION B: GERMAN ARMY, 3rd PANZER DIVISION – FRANCE, 1940.
- VERSION C: GERMAN ARMY,UNKNOWN UNIT POLAND, 1939.
- VERSION D: GERMAN ARMY, UNKNOWN UNIT ON TRAINING GERMANY, 1937.
ITALERI S.p.A.
Via Pradazzo, 6/B
40012 – Calderara di Reno (BO) ITALY
fax: 0039 51 726 459
e-mail: italeri@italeri.com www.italeri.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>