Blackburn 7149593 GRID Side Light Set USB Rechargeable Light User Manual

: June 3, 2024
: Blackburn

Table of Contents

7149593**

DESIGN
SERIES
**User’s ManualGRID™
SIDE LIGHT SET
USB Rechargeable Light

7149593**

QUICK START

Push button to power on.
Click to cycle modes.
Hold 1 second to power off, light powers back on in the last mode used.

FUEL GAUGE

Color LEDs in the power button help you monitor your light battery power, indicating that it’s time to charge your light.
USB CHARGING
Fully charge the light before first use. The fuel gauge will flash when charging. When charging is complete the fuel gauge will be a steady green.
MODES LUMENS RUNTIME AUTO-ECO Solid 110 1.5h –
Pulse 55 4h + 2h
Strobe 40 6h + 2h
ECO 40 20h
Auto-eco switches on automatically at the end of Pulse and Strobe run times for an additional 2hrs of runtime.

MOUNTING

Pull 0-ring around fork and secure to mounting hook.
(2) O-rings 65mm, Large fork
(2) O-rings 35mm, Small fork
INCLUDES
(2) Li Po batteries, (1) Dual-head USB cable, (4) 0-rings

Blackburn 7149593 GRID Side Light Set USB Rechargeable Light - Fig
1

WARNING: Potential choking hazard to children. This light is extremely bright—do not aim directly into eyes. UK ONLY: When used for cycling, this light should be used in conjunction with a British Standard 6102/3 cycle light.
WARNING: This product contains Bisphenol A which is known to the State of California to cause reproductive harm.
FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. Shielded interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules. Specifications and designs are subject to change without any notice or obligation on the part of the manufacturer.

Customer Service: 1-800-456-2355