Blackburn 7134750 Dayblazer 1500 USB Rechargeable Front Light User Manual
- June 5, 2024
- Blackburn
Table of Contents
Blackburn 7134750 Dayblazer 1500 USB Rechargeable Front
Light
- Push button to power on.
- Click to cycle modes.
- Hold down 1 second to power off.
Light powers back on in the last mode used
- The light indicator will blink when charging.
- When charging is complete the light indicator with flash green.
- GREEN = 100% to 75% Battery Capacity
- ORANGE = 75% to 25% Battery Capacity
- RED = <25% Battery Capacity
When battery capacity is 25-35 minutes or less, red indicator light will remain on constant until light reaches 0% or turns off in the selected mode. MAKE SURE TO FULLY CHARGE LIGHT
BEFORE FIRST USE
Ask your retailer for a full warranty policy or visit www.blackburndesign.com/warranty Visit us at blackburndesign.com for product updates
WARNINGS
- Potential choking hazard to children. This light is extremely bright—do not aim directly into the eyes.
- UK ONLY: When used for cycling, this light should be used in conjunction with a British Standard 6102/3 cycle light.
Customer Service: 1-800-456-2355 Blackburndesign.com
limited time Warranty
- 2years warranty
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- A shielded interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.
- Specifications and designs are subject to change without any notice or obligation on the part of the manufacturer.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>