Galaxy 177SV100 Gallon Commercial Sous Vide Immersion Circulator User Manual
- June 3, 2024
- Galaxy
Table of Contents
User Manual
Sous Vide Immersion Circulator
177SV100
Please read the manual thoroughly prior to equipment set-up, operation and
maintenance.
Safety
Please Always Follow These Precautions:
- Use only grounded electrical outlets matching the nameplate rated voltage.
- Use equipment in a flat, level position.
- DO NOT use a damaged cord or an extension cord with this equipment.
- DO NOT plug this equipment into a power strip or multi-outlet power cord.
- Unplug equipment and turn off before cleaning or moving.
- DO NOT fill water level below the “MIN” fill line or above the “MAX” fill line.
- DO NOT spray controls or outside of equipment with liquids or cleaning agents.
- DO NOT clean the equipment with steel wool.
- Keep equipment and power cord away from open flames, electric burners, or excessive heat.
- DO NOT operate equipment in public areas and/or around children.
- DO NOT operate if equipment has been damaged or is malfunctioning in any way.
- Only use this model for intended purpose.
- DO NOT use this model to heat oil, grease, or any other liquid besides water.
- DO NOT put your hands directly in the water.
- The machine may still be hot to the touch right after use.
- To prevent electric hazards, do not immerse cord, plug, or unit in water or other liquid.
Features
Technical Parameters
Model | 177SV100 |
---|---|
Dimensions | 3.0”x4.9”x13.6” (77X124X345mm) |
Voltage | 110V |
Frequency | 60Hz |
Power | 900 W |
Temperature | 41-194°F (5-90 °C) |
Time Setting | 5 min-99 hours |
Accuracy | +/-1°F |
Output | 1.6 gal/min |
Control Panel View and Functions
Time / Temperature Control
-
In standby mode, press to switch temperature or time setting. Press once, which should cause the LEDs to flash, then set the desired temperature with the and buttons.
• To set the time, press again, which will cause the LEDs to flash again. Now use the + and – buttons to set the unit to the desired time.
• To switch between Celsius and Fahrenheit, press and hold the + and – unit at the same time. -
Press one time to confirm the settings you have chosen.
• If is pressed and no selection has been made, the mode will be exited after the LEDs flash 10 times.
• A long press of will display the set time and temperature in turns.
Start / Stop
- In standby mode press to start the machine three
- Press again to start the timer. The temperature will display alternatively with the time every three seconds.
- Press again to stop the machine and return to standby mode.
- Hold the + and – buttons at the same time to switch between Fahrenheit and Celsius.
Operating Instructions
- Select a container for water bath. A water container with a 6″ depth is required to use with this equipment. This unit is designed to heat and circulate up to 8 gallons of water.
- Attach the circulator head to the container via the adjustable clamp.
- Make sure the circulator head is fixed firmly to the container.
- Fill the container with water until it reaches a level between the MAX and MIN fill lines on the circulator head.
- Plug the machine into a grounded electrical outlet matching the nameplate related voltage. The LCD screen will light up once the machine is plugged in.
- Adjust and set controls (see Control Panel View and Functions).
Cleaning and Maintenance
- This model is intended for indoor use only at commercial food service establishments. It is designed to provide precise temperature control of water for closed loop circulation. To extend the life of this model, please clean every 20 uses, or 100 hours of use.
• Do not place the hot machine in cool water. Allow the machine to cool down to room temperature before washing with cool water.
How to Disassemble Quickly
- Use the tool to remove screw.
- Pull out the low part housing to clean the inner components
Cleaning
- Fill the container to the “MAX” line with a solution of 75% water and 25% vinegar.
- Turn on the machine and set the working temperature in 176°F (80°C) with a time of 3 hours (03:00), and press Start. After 3 hours, the machine will beep, then turn off the machine and unplug it to allow it to cool to room temperature.
- Repeat this process with a container full of clean water to rinse
Storage
- Store the model in an upright position after use to prevent water from leaking into the top portion.
- If liquid gets into the top part of the model, turn the power off and dry with a clean towel before use.
Troubleshooting
Problem | Solution |
---|---|
The water level is lower than the lowest water level mark | • Turn off the |
machine power, add the right amount of water to
the container.
No power to the unit| • Ensure the machine is properly plugged into a grounded
outlet.
• Check the power cord for tears, frays, or other damage.
• Do not use machine if the power cord is damaged.
The unit is no longer heating| • Ensure that the water level is between the
MIN and MAX fill lines
marked on the head. If not, allow the unit to cool and add water
until the level reaches between these 2 marks.
Warranty Information
Galaxy warrants its equipment to be free from defects in material and
workmanship for a period of 6 months. This is the sole and exclusive warranty
made by Galaxy covering your Galaxy brand equipment. A claim under this
warranty must be made within 6 months from the date of purchase of the
equipment. Only the equipment’s riginal purchaser may make a claim under this
warranty. Galaxy reserves the right to approve or deny the repair or
replacement of any part or repair request. The warranty is not transferable.
Galaxy Equipment installed in/on a food truck or trailer will be limited to a
period of 30 days from the original date of purchase.
To Make a Warranty Claim: For Warranty Inquiries contact the location
where you purchased the product:
- WebstaurantStore.com: Contact pgjp(Wwebstaurantstore.com. Please have your order number ready.
- The Restaurant Store: If you purchased this unit from your local store, please contact your store directly.
- TheRestaurantStore.com: Online purchases, call 717-392-7261. Please have your order number ready.
Failure to contact the designated location prior to obtaining equipment
service may void your warranty.
Galaxy makes no other warranties, express or implied, statutory or otherwise,
and HEREBY DISCLAIMS ALL IMPLIED WARRANTIES, INCLUDING THE IMPLIED WARRANTIES
OF MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR PURPOSE.
This Limited Warranty does not cover:
- Equipment sold or used outside the Continental United States
- Use of unfiltered water (if applicable)
- Galaxy has the sole discretion on wearable parts not covered under warranty
- Equipment not purchased directly from an authorized dealer
- Equipment used for residential or other non-commercial purposes
- Equipment that has been altered, modified, or repaired by anyone other than an authorized service agency
- Equipment where the serial number plate has been removed or altered.
- Damage or failure due to improper installation, improper utility connection or supply, and issues resulting from improper ventilation or airflow.
- Defects and damage due to improper maintenance, wear and tear, misuse, abuse, vandalism, or Act of God.
Any action for breach of this warranty must be commenced within 6 months of the date on which the breach occurred. No modification of this warranty, or waiver of its terms, shall be effective unless approved in a writing signed by the parties. The laws of the Commonwealth of Pennsylvania shall govern this warranty and the parties’ rights and duties under it. Galaxy shall not under any circumstances be liable for incidental or consequential damages of any kind, including but not limited to loss of profits.
More from Galaxy
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>