anko GP-SW290DC0209-IP44(US) A Low Voltage 600 LED Warm White String Lights User Manual
- June 3, 2024
- Anko
Table of Contents
anko GP-SW290DC0209-IP44(US) A Low Voltage 600 LED Warm White String
Lights
LOW VOLTAGE
600 LED WARM WHITE STRING LIGHTS
These instructions are for your safety. Please read through them thorough-ly
before use and retain for future reference.
Before You Start
- Decide on an appropriate location for your product (see Installation instructions below).
- If you have any doubt about installing this product, consult a qualified electrician. Installation instructions :
- This light is suitable for INDOOR USE ONLY.
- The AC adaptor MUST be installed INDOORS away from weather.
- This light set is constructed with non-replaceable bulbs. When the light source reaches its end of life the whole luminaire shall be replaced
- Do not position or place near heaters or any other direct sources of heat.
- This product is suitable for positioning on surfaces which have normal flammability, e.g. wood, plasterboard, masonry. However this does not include highly flammable surfaces (e.g. polystyrene, textiles).
- Always position cables and extension leads so that they will not be a hazard to the elderly, pets and children.
- DO NOT position this light set where it may become covered by other items e.g. nets or bedding.
- Ensure the unit is positioned so that you have enough cable to reach an indoor mains power socket.
- To change the light effect, simply press the button locate on top of the AC Adaptor
INSTALLATION
- COMBINATION
- IN WAVES
- SEQUENTIAL
- SLO-GLO
- CHASING / FLASH
- SLOW FADE
- TWINKLE / FLASH
- STEADY ON
Keycode: 43199334
Adaptor:
The ratings shown on the marking is steady mode, and the input power up to
3.6W. Adaptor other mode see below:
PRI: 220-240V~ 50-60Hz 0.12A
Urated=31V~
Uout=34V~ Prated Max 3.6W
Warning
- This light is suitable for INDOOR ONLY.
- The AC adaptor MUST be installed INDOORS away from weather.
- This product is NOT designed for permanent or long term use.
- The supplied adaptor is suitable for operation of LED Modules only.
- Only operate this light set with the supplied adaptor, Model No.:JT-EL/FC31V3.6W-H9
- Do not connect this light electrically to another light.
- Do not connect this light to the power supply while it is in the packaging.
- DO NOT attempt to replace the non-replaceable bulbs in this light.
- Never allow any part of the light set to come into contact with a source of heat or flame.
- Care must be taken to avoid damage the cable or fittings.
- If any part of light set or cable is damaged, the light set MUST be discarded.
- This product is for use as a decoration only. Not to be used by children as a toy. Keep out of reach of children.
- Do not position this light where it will be exposed to extreme wet weather or submerged in water.
- Always switch off this light set or unplug an adaptor if unattended.
- DO NOT overload power sockets or extension leads.
- DO NOT pierce the cable when securing in place, as this will damage the bulbs or wiring.
- Please refer to the packing or product rating label for product class, specifications and rating. LED Bulbs
This light set is constructed with non-replaceable bulbs. DO NOT attempt to replace any of the bulbs in the light set.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>