eldes EWC1AM Curtain Motion Detector User Guide
- June 3, 2024
- eldes
Table of Contents
eldes EWC1AM Curtain Motion Detector User
CURTAINN MOTION DETECTOR EWC1AM
DEVICE ACTIVATION
- Unscrew a single screw to open the plastic enclosure.
- Check the position of DIP switches: DIP1 and DIP3 must be ON,while DIP2 and DIP4 switches must be OFF.
- Gently remove the hardware board (use a screwdriver).
- Insert and connect the battery.
- Check and remember (write down) the ID number of EWD3 device.
- Mount the devices plastic enclosure to the wall or another surface (follow the recommendations from the original manufacturer’s manual] NOTE: The package includes 2 different mounting bases. ATTENTION!: Before mounting the device, you must check the wireless signal first!
- Put the hardware board back in its place
- Close the plastic enclosure.
- Screw in the plastic endosure (use the single screw).
- Connect the device to the system via Eldes Utility software.
DEVICE CONNECTION TO THE SYSTEM
- Launch Eldes Utility software and add the new EWD3 device to the system using its ID number (see DEVICE ACTIVATION step No 5).
- Configure the first EWD3 zone (Zone 1), setting it as a ‘Digital zone NOTE: Digital zone’ is designed for causing an alam (by default) if the wired digital sensor, connected to Z and cOM terminals, is triggered, while the system is armed. This mode does NOT operate with Flood sensor mode on Zone 2 simultaneously.
- Change zone’s name (optional).
- Set zone type to Instant.
- Set the ‘Alarm Count to Bypass’ value to zero (0).
- By default, zone’s attributes ‘Force’and Stay’are turned ‘OFF. We recommend leaving it like that.
- Set the ‘Input connection mode’ to ‘NC position.
- Set the Tamper Enabled’ option to ‘ON
- Change tampers name (optional).
- Save the configuration (click ‘Write settings).
Please be aware that the new Eldes solution is based on a third-party device. For more information about this solution, visit eldesalarms.com.
According to the original manufacturer’s manual, the detault TInhibition time” between alarms is up to 5 minutes Please check the original manufacturers manual for more details.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>