FRESCA tuna 50 Inch Wide Cabinet Owner’s Manual

FRESCA tuna 50 Inch Wide Cabinet

IMPORTANT SAFETY INSTRUCTIONS

When using electrical furnishing, basic precautions should always be followed, including the following:

• To reduce the risk of burns, fire, electric shock or injury to persons.
• Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer. Never drop or insert any object into any opening. Do not use outdoors.
• Risk of electric shock. Connect this furnishing to a properly grounded circuit only. See grounding instructions.

ELECTRIC CONNECTIONS

ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENCED ELECTRICIAN.

• Shut off power before wiring.
• Requires 120 VAC 20 Amp GFI protected Circuit.

GROUNDING INSTRUCTIONS
This product must be connected to a grounded metal permanent wiring system or an equipment-grounding conductor must be run with the circuit conductors and connected
to the equipment grounding terminal or lead on the product.

An Electrical option mirror must be wired to a 20 Amp GFI(Ground Fault
Interrupter) protected circuit when used in bathrooms and all other locations required by the National Electric Code.

HOW TO CONNECTIONS

If there is a suitable socket on the wall, plug in the mirror’s own plug and you can use the electric functions. If a cord is reserved on the wall behind the hanging mirror, please cut off the plug of the wire on the mirror and connect them according to steps A and B.

HARDWARE AND TOOLS

HOW TO USE DOOR BUMPER

INSTALLATION INSTRUCTIONS

APPLY TO THE BELOW STYLE OF LED MEDICINE CABINET

Please read carefully and save these instructions Don’t discard any of the packaging until you are sure that you have all of the parts and the fittings Make sure the power to the junction box is off before commencing installation.

IMPORTANT

1.  Unpack the LED cabinet. DO NOT lay the cabinet on the tiled or concrete surface prior to installation Cabinet must be on a protected surface to prevent chipping of the corners
2.  Care must be taken before drilling pilot holes to avoid any existing wiring or pipe work that may be concealed.
3.  A certified electrician must perform all work. The mirror must be connected to a GFI

INSTALLATION
Please refer the installation diagram on the next two installations manual.

1. Unpack the LED medicine mirror and prepare the tools needed.(See Pic.1)
2. Make sure the measurement on the cardboard screw holes are matching up with the aluminum base on the mirror back, then mark the screw holes according to the cardboard with a pencil.(See Pic.2)
3. Drill holes,and put in the plastic expansion bolt, then fix the aluminum bar by screws (See Pic.3&Pic.4);
4. Connect hardwire to the power line.Make sure the power off(Voltage:AC110-12V,50/60Hz)(See Pic.5)
5. Hang the cabinet on the wall; don’t remove your hands until its safe.(See Pic.6)
6. Connect the lower end of wall with the cabinet body by using the corner brace.(Pic.8)

MAINTENANCE

Wipe clean with a soft damp cloth. Apply glass cleaner to a cloth and do not apply directly to mirror Never use abrasive cleaners as these could damage the finish or exposed LEDstrip 2

Installation

INTRODUCTION OF TOUCH FUNCTION

Note: All dimensions & specifications are approximate and subject to change without notice.

For any questions or queries regarding our products, please contact our support team- at customerservice@tunuo.net or call （909）9907895 Visit our website for more information https://tunuo.net

References

• tunuo – smart bathroom living

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>