Skyline Brands 28NR Joist Reinforcer Instruction Manual
- June 3, 2024
- Skyline Brands
Table of Contents
Brands 28NR Joist Reinforcer
Instruction Manual
Installation Instructions for 28NR/210NR Joist Reinforcer
Use the 28NR Joist Reinforcer for 2×8 Joists and the 210NR Joist Reinforcer to reinforce 2×10 and 2×12 joists.
Installation
Center the notch of the 210NR Reinforcer on the notch in the top or bottom of
the affected joist, placing it against the face of the joist with the flange
of the Reinforcer in contact with the underside of overlying sheathing.
Place a No. 12 wood screw in each of the face holes in the Reinforcer driving
each snugly into the joist. Proper size screws are provided with the
Reinforcer. Screws in the top and bottom flange holes of the 210NR are
optional.
Installation Limitations
- Joists: Joists may be 2×8, 2×10, or 2×12 Solid Sawn Lumber with spans in accordance with Tables R502.3.1 (1) and R502.3.1 (2) of IRC 2012 and IRC 2015
- Location: The center of the 210NR must be at least 12″ from any bearing support of the joist.
- Adjacent Holes: Holes of 1.5″ maximum diameter may be installed in the joist adjacent to the 210NR as long as they are spaced at least 20″ from the edge of the 210NR.
- Notch Size: Notch sizes may not exceed 5″W x 3″D.
- Number of 210NR’s: One 210NR may be applied per joist.
- Non-Compliant Installations: It is often possible to use a 210NR in conditions not complying with these Limitations. Contact Metwood for additional product and engineering support.
Skyline Brands, LLC
415 Elm Ave. SW
819 Naff Rd.
Boones Mill, VA 24065
www.metwood.com
References
- Floor joist repair hole and notch repair and reinforcing hardware – Skyline Building Solutions
- Steel Building Products | Metwood Building Solutions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>