HOMEDEPOT W1WCR4986SS Telescoping Stainless Steel Window Curtain Rod Instructions
- September 2, 2024
- HOMEDEPOT
Table of Contents
INSTALLATION
STEP 1. Place brackets against wall or ceiling at desired locations and
mark screw holes. Use tape measure and level to make sure marked screw holes
are horizontal to each other. Pre-drill two pilot holes for each bracket (1/4″
drill bit) and insert anchors into wall/ceiling and insert screws into wall
anchors.
STEP 2. If mounting directly into wood or studs, pre-drill two pilot
holes for each bracket (1/4″ drill bit) and install bracket on the wall with
screws provided.
STEP 3. Determine projection of brackets. Loosen projection screw, slide
bracket to desired position and tighten projection screw. Repeat for each
bracket.
ROD INSTALLATION
STEP 4. Detach finial from inner rod.
STEP 5. Assemble rod and shirr drapery treatment onto rod.
STEP 6. Screw finials onto inner rod. Rotate finial on rod for proper
alignment if required.
STEP 7. Extend rod to desired width and place it into the brackets.
Adjust draperies to desired position.
FINAL ADJUSTMENT
STEP 8. Secure each rod by tightening screws provided.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>