John Adams 11103 Super Aqua Park Playset Instruction Manual

June 3, 2024
John Adams

John Adams 11103 Super Aqua Park Playset

INSTALLATION INSTRUCTION

  1. Start your new creation by adding the correct amount of Solution Mix and clean water to the included reusable Creation Play Tank. SEE MIXING CHART for correct amounts of water and Solution Mix needed. If the indicated proportions of water and Solution Mix are not followed the Solution will not work properly. Stir until the Solution Mix is completely dissolved in the water.
    NOTE: Your Solution can be reused over and over. Store in a safe location and cover. Do not add more water when reusing or the effectiveness will be reduced.

  2. Choose a character mould. To prepare it for gel and ensure easy gel release, give it a quick dunk into the Solution, lift out, tap & shake off excess solution. Under the cap of each Gelz squeeze bottle is a sealing plug which must be removed prior to use. Unscrew the Gelz bottle cap, remove plug and dispose of in household trash and replace cap on the bottle.

  3. Start your creation by gently twisting the Gelz cap counter-clockwise to open, and then squeezing the coloured gel into your character mould. It is recommended to not over fill the mould past the top edge of the mould. When done, be sure to close each gel by gently twisting cap clock-wise.
    NOTE: AFTER YOU GENTLY TWIST TO OPEN CAP, DO NOT PULL CAP OFF.

  4. Place the Gel-filled mould into the Creation Play Tank once again, this time submersing it completely. While submersed in the solution, wiggle your mould side to side gently until your character releases from the mould. It will release in 10-30 seconds. Once creation releases from the mould let it remain in the solution tank until it firms. Be gentle touching the Creation during the firming process.
    NOTE: For a softer creation remove from Solution sooner. For a firmer character leave in Solution longer. If Creation is not firm enough it can be placed back
    into Solution until desired firmness is reached.

  5. Test your Creation by gently squeezing it from time to time. Once your creation has reached the desired firmness, transfer it into another container filled with only plain clean water or Display Fish Tank (Aqua Gelz Deluxe Playset only). The firming process will stop once taken out of the Solution. It’s time to have hours of fun playing with your new creation.
    NOTE: Always store your creation in water or it will harden and shrink. DO NOT throw away your Solution or Solution Tray as both can be reused again and again. Store in a safe location and cover when not in use. When reusing the solution Do not add more water. To make a new batch of Solution start with Step 1 & follow the Solution Mixing Chart.

NOTE:
DO NOT DISCARD CREATION PLAY TANKJohn-Adams-11103-Super-Aqua-Park-Playset-
fig-8

Solution Mixing Chart

IMPORTANT
For proper forming of creations it is necessary to follow the chart above Solution can be reused many times – do not discard until dirty or cloudy. When emptying Solution, first remove Creation Play Tank from the
paper base for easier handling.
WARNING! Not suitable for children under 36 months. Choking hazard – contains small parts. Avoid contact with eyes and do not swallow content. This is not a food product. Adult supervision required.

DISPOSAL: Prepared Aqua Gelz Solution can be poured down a sink drain. Solution Mix, Gel or creations can be disposed of in ordinary household garbage.

ATTENTION: Avoid getting coloured Gelz on clothing, carpet, furniture or walls. If contact occurs wash immediately with detergent and water. Gel which is allowed to dry may stain.
Avoid contact with eyes and do not swallow content. This is not a food product. If ingestion takes place immediately see medical advice. In case of eye contact rinse with clean water and immediately seek medical advice.

  • Do not place Solution, Gelz, or creations in ears or nose. If any part of this toy becomes lodged in nose or ears immediately seek medical advice.
  • Do not use the product when there is a risk of contacting wounds or broken/damaged skin. Discontinue use if redness or itching occurs on contact with skin. If symptoms persist contact a doctor.

© 2021 Zoinks™. All rights reserved. ZOINKS™ LTD., 12/F King Palace Plaza No. 55 King Yip Street, Kwun Tong, Kowloon Hong Kong. Patent Pending and Copyright Granted. For inquiries email us at [email protected] or visit us at www.zoinksasia.com. Product color and styles may vary. Please retain Instructions and packaging for future reference.
Distributed by John Adams Leisure Ltd., PE28 4YA, England.
EU authorised representative: John Adams Leisure EU Ltd.,
D06 H685, Ireland. For customer services call 01480 414361 or
email [email protected]
To see more of our range visit www.johnadams.co.uk

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

John Adams User Manuals

Related Manuals