MODSTER AN-294590 SC L7 Electric Longboard Electric Skateboard User Manual

MODSTER AN-294590 SC L7 Electric Longboard Electric Skateboard User Manual

INTRODUCTION

Thank you for purchasing our electric longboard.
Please note that an electric longboard is not a toy.
Please take your time to learn how to use it & read this manual carefully, especially the safety instructions. We hope you will enjoy this product and have fun with it in the future.

PREPARATION

1. Make sure that your helmet and protective equipment are ready.

2. Check if the longboard is positioned in the right direction.

3. Check your position on the longboard: Your feet must be on the widest front and back part of the board.

4. Use the lowest speed mode to become familiar with acceleration and braking.

5. Use the brake function of the remote control to stop the longboard, then first step down with the front foot and then step down with the back foot.

PARTS DIAGRAM

1. Front Truck
2. Deck
3. Battery Case
4. LED Light
5. Heat Sink
6. Charging Port
7. Power Button
8. Drive Truck

FERNSTEUERUNG

PAIR INSTRUCTION

The first step is to connect the board and the remote control.
Before you start, make sure that the board and the remote control are switched off.

• Switch on the board.
• Press the power button for 5 seconds until the light of the power button starts flashing.
• Turn on the remote. Press the pairing button, the signal indicator will flash.
• Push the joystick to test acceleration and braking.
  

LED LIGHTS

Activation/deactivation by pressing the reverse button on the remote control for 3 sec.

SPECIFICATION

SAFETY INSTRUCTIONS

• The electric skateboard is not a toy, should be treated with appropriate caution. Always practice safety first-as it is possible to lose balance and cause a collision or fall. Ensure that you use the board in a safe appropriate environment, and always wear appropriate safety gear.

• Safety Gear: we recommend that you wear full safety gear while riding. Please wear a suitable skateboard helmet, elbow pads, knee pads, and gloves.

  ---

• Wear good shoes: flip-flops or similar loose footwear are not suitable for skateboarding.

• The skateboard is designed for riders over 12 years and older.

• Only one person riding for each skateboard at a time. The maximum load of the board is 100kg. Exceeding this weight will compromise the structural integrity of the skateboard, as well as remote and functionality, and may cause board damage, losing control or other breakage.

• Please observe the local traffic rules and regulations in your country.

• The board is designed to drive on flat, dry and paved surfaces. Avoid driving on sand, gravel, mud, rugged or open ground. Do not drive on slippery ground, such as snow, ice or wet ground. Do not jump with the board, do not drive over curbs and do not slide over obstacles.

• Keep fingers, hair and clothing away from the motors, wheels and moving parts, wheels and moving parts.

• Do not open the electronics- and battery housing and do not tamper with it. Electric shock is possible and will void the warranty.

CHARGING INSTRUCTION

Lithium batteries can explode or cause a fire if mishandled

Please treat your skateboard batteries as follows:

• Before each charging process and each use of the board, check the battery and charging connection for mechanical damage.
• Never drop the board.
• Don’t jump with the board, don’t slide over curbs or railings
• Store the board in a dry place and charge only in dry conditions.
• Never expose the battery to high temperatures.
• Only use the supplied charger.
• Never charge the battery unattended, charge on a non-flammable surface.
• Never open the battery compartment – this will lead to loss of warranty.
• If you do not use the board for a longer time, recharge the battery monthly.
• Do not store the board with a discharged battery or with a fully charged battery.
• Lithium batteries “are best stored at around 60% state of charge.
• Deeply discharged batteries are irreparably damaged and may no longer be used or charged – caution, risk of fire!
• Fully charge the battery immediately before first use.
• Please first plug the charger into the socket (240V) and only then connect it to the charging port of the skateboard.

DISCLAIMER OF WARRANTY

• The maximum total weight and load must not be exceeded. High loads in connection with overloading operation of the device can lead to structural damage. Jumping with the device is not allowed and leads to loss of warranty, as well as driving through potholes and the like. Driving on cobblestones leads to increased wear!
• Only one person is allowed to drive at the same time
• The device is designed for operation on flat, smooth surfaces. It must not be used on sandy, muddy, wet, slippery, icy or snow-covered floors. Driving in rain and snow is not allowed.
• Don’t jump with the board, don’t slide over curbs, railings and other objects!
• Do not disassemble or repair the device by yourself. This leads to LOSS OF WARRANTY.
• Do not store the device with empty batteries. The state of charge of the battery needs to be checked each month and recharged if needed. Never charge unobserved!
• Cleaning the device with high pressure cleaners or using a garden hose is not allowed. Wipe only with a damp cloth.
• Depending on the load, the device is subject to more or less severe wear. This can lead to deflection of the steering, wheel bearings, folding mechanism and the like; this is not covered by the warranty. Brakes, tires, drive chains and sprockets are wearing parts and are not covered by the warranty. The drive battery is designed for 200 charging cycles. A gradual decrease in performance cannot be avoided and is not covered by the warranty.
•  Store the device in a dry place at a temperature between 10 ° – 30 ° C.
• Only use the original charger and never charge the battery unobserved
• Do not exceed the design speed of the device. This can easily be exceeded, especially when driving downhill.
• In any case, find out about the legal regulations applicable in your country for the use of e-skateboards in public spaces.

MSD Online GmbH

Declaration of Conformity

Hiermit wird erklart, dass folgendes Produkt:

MODSTER SC L7 e-Skateboard: Artikelnummer: 294590 (EAN: 4260752718554)

Comply with the essential requirements and the other relevant provisions of the Directive (EMC) 2014/30/EU.

Manufactured in accordance with the following harmonised standards:

1. EMC Directive 2014/30/EU
   EN-61000-3-3:2013 +A1:2019
   EN-55032
   EN 301 489-1 V2.2.0 (2017-03)
   EN 301 489-17 V3.2.0 (2017-03)

2. Machinery Directive 2006/42/EC
   EN ISO 1210:2010
   EN 60204-1 :2006 + Al :2009

3. Low Voltage Directive 2014135/EU (For Charger
   ) EN-60335-1:2012 +A11:2014
   EN 62233:2008

4. Radio and Telecommunication Terminal Equipment (RTTE) Directive 2014/53/EU (For remote Control)
   EN 300 220-1 V2.4.1 (2012-05)
   EN 300 2020-2 V2.4.1 (2012-05)
   EN 301 489-1 V2.2.0 (2017-03)
   EN 301 489-17 V3,2,0 (2017-03)
   EN 300 328 V2.1.1 (2016-11)

5. RoHs Directive 2011/65/EU

6. Health
   EN-62311 :2008

Hersteller / verantwortliche Person: MSG Online GmbH, Walter Bittdorfer
Manufactor/ responsible Person: Wirtschaftspark 9
Fabricant / personne responsable: 8530 Deutschlandsberg, Austria

Walter Bittdorfer
Geschaftsfahrer/ managing director/ directeur gOnOral Ort / Datum; Place of issue / Date:
Deutschlandsberg (Austria), 04.01.2021

References

• MODSTER

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>