MODSTER R3 Electric E-Skate Board User Manual
- June 4, 2024
- MODSTER
Table of Contents
MODSTER R3 Electric E-Skate Board
Thank you for order our electric skateboard
Do note that electric skateboard is not a toy. Please take time to learn it
and read this manual carefully. Particularly the safety instruction pages. We
hope that you will enjoy the product and have losts of fun with it in the
future.
PREPARATION
- Be sure that wear a helmet and safety gear when you ride it
- Confirm the front direction of the skateboard
- Confirm the position on the skateboard, The feet stand on the widest front and back skateboard.
- Please start with the low speed mode to be familiar with the accelerate and brake of the skateboard.
- When stop riding by brake operate. Get down front foot at first,then get down your back foot.
PARTS
- Deck
- PU Wheel
- Front truck
- Switch
- Hub motor
- Battery case
- Heat sink hole
- Bulge
- Hook
- LED Light
REMOTE CONTROL
PAIRING THE SKATEBOARD
The first step,the BOARD and REMOTE must be paired. Before riding,to ensure the BOARD and REMOTE are turn off.
- Turn on the board.
- Press the board power button for 5 seconds.lt will flash.
- Turn on the remote.Press the pairing button,the signal indicator will flash.
- Push the joystick to test acceleration and braking.
REMOVEABLE BATTERY
- Use index finger to push the bulge
- Use another hand’ sindex finger and thumb to press the hook
- Push and pull the battery pack at time
- Pull out the battery pack
SPECIFICATION
SAFETY INSTRUCTIONS
- The electric skateboard is not a toy, should be treated with appropriate caution. Always practice safety first-as it is possible to lose balance and cause a collision or fall. Ensure that you use the board in a safe appropriate environment, and always wear appropriate safety gear.
- Safety Gear:. we recommend that you wear ful safety gear while riding. Please wear a suitable skateboard helmet, elbow pads, knee pads, and gloves.
- Wear shoes: Flipflops or similar loose footwear are not suitable for riding wear.
- The skateboard is designed for rider over 14 years old and above.
- Only one person riding for each skateboard at a time. The maximum load of the board is 150kg. Exceeding this weight will compromise the structural integrity of the skateboard, as well as remote and functionality.and may cause board damage, losing control or other breakage.
- Please observe your local traffic laws and regulations.
- The board is designed to drive on flat and paved surfaces. Avoid driving on sand, gravel,mud, rugged or open ground. Do not drive on slippery ground, such as snow, ice or wet grOund.
- Keep fingers, hairs, and clothing away from motors, wheels and moving parts.
- Do not open or tamper with electronics housing.
- Electricshock is possible and this also voids the warranty.
- Caution: do not store the board with empty battery-charge the battery at least all 3 month
Range information, as well as information on maximum speeds and incline ability are heavily dependent on parameters such as the state of charge of the battery, condition of the ground, inclines or declines during the route, weight of the person driving, physical performance by diving or, if available, use of the pedals, weather conditions, headwind and depending on other factors. Our information relates to the optimal case.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>