ozito OWBK-30 30W 240V Wood Burning Project Kit User Manual
- June 3, 2024
- ozito
Table of Contents
ozito OWBK-30 30W 240V Wood Burning Project Kit
Ozito Industries Pty. Ltd. 25 Fox Drive, Dandenong South, Victoria, Australia 3175.
ONLINE MANUAL
Scan this QR Code with your mobile device to take you to the online manual.
OPERATION
ACCESSORIES
Choosing Tips
- The long edge is ideal for marking thin lines and wide, deeper lines.
- The pointed tip can be used for marking dotted patterns or lettering.
- The angled tip can be used for shadow marking.
- The branding tips can be used to make repeated pattern imprints.
-
The hot knife tip is suitable for cutting foam or melting the ends of cords made of nylon or synthetic materials.
-
WARNING! ENSURE THE TOOL IS UNPLUGGED AND COMPLETELY COOLED BEFORE CHANGING THE TIPS.
-
WARNING! THE THREADS ON TIPS ARE EASILY DAMAGED WHEN HOT. ENSURE THE TIP IS COMPLETELY COOLED BEFORE SWAPPING TIPS.
-
WARNING! NEVER USE TOOLS SUCH AS PLIERS TO LOOSEN/TIGHTEN THE WOOD BURNING TIPS. THESE SHOULD BE FINGER-TIGHT ONLY & USE OF TOOLS CAN DAMAGE THE THREADS.
USAGE
Using The Templates
-
Lay the waxy/chalky side of the carbon paper down onto the timber project board supplied.
-
Place the desired drawing template onto the carbon paper.
Note: Three drawing templates have been included to get you started, however you can also print out and use different designs.
Note: Use a clamp, large bulldog clips or masking tape to secure one corner of the template and carbon paper against the timber. This will prevent the template from shifting while you are transferring the design but also allow you to lift the papers and check how the pattern is transferring. -
Use the pencil to trace over the outline of the design on the template.
-
If you make a mistake while tracing, erase the lines before burning as the heat from the tool will set the lines and make them harder to remove after.
Note: Avoid pressing down overly hard while transferring the pattern as this will make any unwanted lines harder to remove also. -
Once you are happy with the transferred artwork you can proceed with wood burning.
WARNING! ENSURE YOU ARE WORKING IN A WELL VENTILATED AREA AND WEARING APPROPRIATE SAFETY GEAR.