ASUS EMA-DCB-A AIoT and Industrial Solutions User Manual

June 3, 2024
Asus

ASUS-logo

ASUS EMA-DCB-A AIoT and Industrial Solutions

ASUS EMA-DCB-A-AIoT-and-Industrial-Solutions-product-
img

October 2021
Copyright © 2021 ASUSTeK COMPUTER INC. All Rights Reserved.
No part of this manual, including the products and software described in it, may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means, except documentation kept by the purchaser for backup purposes, without the express written permission of ASUSTeK COMPUTER INC. (“ASUS”).
Product warranty or service will not be extended if: (1) the product is repaired, modified or altered, unless such repair, modification of alteration is authorized in writing by ASUS; or (2) the serial number of the product is defaced or missing.
ASUS PROVIDES THIS MANUAL “AS IS” WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OR CONDITIONS OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL ASUS, ITS DIRECTORS, OFFICERS, EMPLOYEES OR AGENTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES (INCLUDING DAMAGES FOR LOSS OF PROFITS, LOSS OF BUSINESS, LOSS OF USE OR DATA, INTERRUPTION OF BUSINESS AND THE LIKE), EVEN IF ASUS HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES ARISING FROM ANY DEFECT OR ERROR IN THIS MANUAL OR PRODUCT.
SPECIFICATIONS AND INFORMATION CONTAINED IN THIS MANUAL ARE FURNISHED FOR INFORMATIONAL USE ONLY, AND ARE SUBJECT TO CHANGE AT ANY TIME WITHOUT NOTICE, AND SHOULD NOT BE CONSTRUED AS A COMMITMENT BY ASUS. ASUS ASSUMES NO RESPONSIBILITY OR LIABILITY FOR ANY ERRORS OR INACCURACIES THAT MAY APPEAR IN THIS MANUAL, INCLUDING THE PRODUCTS AND SOFTWARE DESCRIBED IN IT.
Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners’ benefit, without intent to infringe.

Package contents

Check your DC power board package for the following items.

  • 1 x ASUS EMA-DCB-A DC Power Board
  • 1 x Low-profile bracket
  • 1 x Power cable
  • 1 x Screw package

NOTE : If any of the above items is damaged or missing, contact your distributor or sales representative immediately.

Features

  • 12V DC-IN converted to 24+4 pin ATX power out, supporting up to 12V/10A
  • Overvoltage Protection: 15.5V
  • Overcurrent Protection: 20A
  • Wide temperature range endurance: 0°C~60°C
  • Lockable DC-in Jack
  • Compatible with ASUSIoT Mini ITX-motherboards

Specifications




Power limit

| Input voltage

– 12V ±5%

– OVP:15.5V

Output current

–   Maximum DC output: 12V/10A

–   OCP: 20A

– OPP: 240W (12V*20A)

---|---
DC power board connectors| Power input

–   Lockable DC-in jack Power output

–   4-Pin ATX connector


Power cable connectors

| 1  x ATX 24-pin connector (Output) 1 x ATX 4-pin connector (Output) 1 x ATX 4-pin connector (Input)

2  x SATA Power connectors (Output)


Supported motherboards

| Q370I-IM-A Q370I-IM-A R2.0 H310I-IM-B Q470EI-IM-A

W480EI-IM-A

Operation

Temperature

| 0~60°C
Non- Operation

Temperature

| -40~85°C
Relative Humidity| 10%~95%
Dimension| 60 37 12 mm (LWH)
Weight| 15g
Certification| EMC: CE, FCC

NOTE : Specifications are subject to change without notice.

DC power board information

DC power board layoutASUS EMA-DCB-A-AIoT-and-Industrial-Solutions-fig-
\(1\)

 12V DC-IN jack  4-pin ATX connector

Installing your DC power board

To install your DC power board:

  1. Insert the 12V DC-IN jack on your EMA-DCB-A DC power board into the hole on the bundled bracket.
  2. Place and thread the bundled washer and nut onto the 12V DC-IN jack.
  3. Align the holes on the 12V DC-IN jack side of your DC power board and on the bottom of the bracket, and then secure them with the bundled screws.
  4. Attach the bracket to the chassis and secure it with the bundled screw.
  5. Connect the DC power board to a compatible motherboard with the bundled power cable.ASUS EMA-DCB-A-AIoT-and-Industrial-Solutions-fig- \(3\)

FCC Compliance Information

Responsible Party: Asus Computer International
Address: 48720 Kato Rd., Fremont, CA 94538, USA
Phone / Fax No: (510)739-3777 / (510)608-4555

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Compliance Statement of Innovation, Science and Economic

Development Canada (ISED)
This device complies with Innovation, Science and Economic Development Canada licence exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems.
CAN ICES-003(B)/NMB-003(B)

REACH

Complying with the REACH (Registration, Evaluation, Authorisation, and Restriction of Chemicals) regulatory framework, we published the chemical substances in our products at ASUS REACH website at http://csr.asus.com/english/REACH.htm.
DO NOT throw the motherboard in municipal waste. This product has been designed to enable proper reuse of parts and recycling. This symbol of the crossed out wheeled bin indicates that the product (electrical and electronic equipment) should not be placed in municipal waste. Check local regulations for disposal of electronic products.
DO NOT throw the mercury-containing button cell battery in municipal waste. This symbol of the crossed out wheeled bin indicates that the battery should not be placed in municipal waste.

ASUS Recycling/Takeback Services

ASUS recycling and takeback programs come from our commitment to the highest standards for protecting our environment. We believe in providing solutions for you to be able to responsibly recycle our products, batteries, other components as well as the packaging materials. Please go to http://csr.asus.com/english/Takeback.htm for detailed recycling information in different regions.
Regional notice for California

WARNING

Cancer and Reproductive Harm – www.P65Warnings.ca.gov
Google™ License Terms
Copyright© 2021 Google Inc. All Rights Reserved. Licensed under the Apache License, Version 2.0 (the “License”); you may not use this file except in compliance with the License. You may obtain a copy of the License at:
http://www.apache.org/licenses/LICENSE-2.0
Unless required by applicable law or agreed to in writing, software distributed under the
License is distributed on an “AS IS” BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
See the License for the specific language governing permissions and limitations under the License.

ASUSTeK Computer Inc. hereby declares that this device is in compliance with the essential requirements and other relevant provisions of related UKCA Directives. Full text of UKCA declaration of conformity is available at: www.asus.com/support

Service and Support
Visit our multi-language website at https://www.asus.com/support/

Manufacturer ASUSTek COMPUTER INC.
Address, City 1F., No. 15, Lide Rd., Beitou Dist., Taipei City 112,

Taiwan
Authorized Representative in Europe| ASUS COMPUTER GmbH
Address| Harkortstrasse 21-23, 40880 Ratingen
Country| Germany
Authorized Representative in United Kingdom| ASUSTEK (UK) LIMITED
Address| 1st Floor, Sackville House, 143-149 Fenchurch Street, London, EC3M 6BL, England
Country| United Kingdom

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals