Jupiter Creations 17006 ROBO Shark Instruction Manual
- June 3, 2024
- Jupiter Creations
Table of Contents
Jupiter Creations 17006 ROBO Shark
SHARK AND REMOTE CONTROL BATTERY INSTALLATION
- Using a Phillips screwdriver, open the compartment lid (A) under Roboshark’s mouth.
- Using a Phillips screwdriver, open the waterproof battery compartment (B),
- Insert 3 AAA batteries (Not Included) according to polarity symbols (+).().
- Close the waterproof cover and tighten the screws to prevent water from entering.
- Using a Phillips screwdriver open the battery compartment (C) behind the remote control and insert 3 AAA batteries (not included) Close the compartment.
IMPORTANT: Roboshark’s motor will only run when the shark is in the water.
OPERATION AND FUNCTION OF REMOTE CONTROL
How to pair Roboshark with remote control
-
To pair the remote control to the Roboshark, please follow the steps above to insert batteries. Once the batteries are in, turn on the remote control.
-
The light on the remote will start to blink. Turn on the shark. If the light in the remote stops blinking, then the remote and Roboshark are paired and you are ready to test the waters.
If the lignt on the remote keeps blinking, the pairing was unsuccessful and you will have to turn the remote and RODOShark off and try again. -
Please note, the shark will not function unless it is in the water. The motor will stop working as soon as you remove Roboshark from the water.
WARNING:
- This product is a children’s toy that should only be played with on the water using the 2.4GHz wireless Remote control.
- Roboshark is waterproof however the remote control is not. Keep the remote control away from water,
- After each use, dry Roboshark completely using a towel.
WARNING:
Never allow young children to play in or around water without adult
supervision.
2022 Jupiter Creations, Inc. All rights reserved
www.jupitercreations.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>