MERLYN MIND Symphony Classroom Wall Mount Installation Guide

: June 12, 2024
: MERLYN MIND

Table of Contents

Symphony Classroom Wall Mount
Included Hardware
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Symphony Classroom Wall Mount
Installation Guide MERLYN MIND Symphony Classroom Wall
Mount Wall Mount Assembly
Mounting Kit for Symphony Classroom™ Installation Guide

Symphony Classroom Wall Mount

WARNING / IMPORTANT SAFETY NOTICE

Do not install the wall mount or the display mount until you have fully read and understood this installation guide.
Incorrect or improper installation of this product may cause injury or property damage.
Do not use the wall mount and display mount other than what is specified in the manual.
Only qualified personnel or a mechanically proficient person should install this wall mount or display mount.
Installers are responsible for checking the suitability of the wall in which the unit is being mounted on.
It is recommended to have two people when lifting or mounting is involved.
For wall mounting on drywall material or similar surfaces, please use the included plastic anchor for a more secure mount.
Our product is intended for indoor use only; do not mount the unit outdoors as it can cause product damage or physical injury.
Tighten the screws, but not over-torque them.
Please contact tech support if you have any questions or comments

Limited Warranty Statement:
Your Product Accessory is covered by a Merlyn Mind, Inc. One-Year Standard Limited Warranty, the terms of which can be viewed at merlyn.org/support.

Included Hardware

Note: This list does not include pre-installed hardware or tools.

| Screw (x4)
M6x3.0x54 mm
---|---
| Screw (x2)
M6x1x12
| Plastic Insert (x4)
| Screw (x3)
M5x0.8×15 mm
| Nut (x2)
M6x1 mm

Drill four holes in the wall using the diameter and spacing shown below. If installing in drywall, hammer a plastic anchor into each hole.
Attach mounting plate to wall.
Remove screws from mounting plate.
Attach mounting arm to the mounting plate and pull cables through the mounting arm.
Attach faceplate over the mounting assembly.
Detach hang hooks from swivel hardware.
Attach hang hooks to mounting assembly.
Attach adapter plate to swivel hardware.
Attach swivel hardware to Symphony Classroom™ unit.
Attach unit to mounting hardware using the hang hooks. Tighten swivel hardware to secure. Attach endcap.
The final result of the Symphony Classroom™ wall mounting assembly.