SOUNDSTREAM SR1-3000 1-Channel Amplifier Owner’s Manual
- June 7, 2024
- SoundStream
Table of Contents
SOUNDSTREAM SR1-3000 1-Channel Amplifier
Panel Definition
**SR1-1500
**
**SR1-3000
**
Features & Functions:
Input Connection:
Output connection:
Again, high current barrier strip terminals are provide for connection to the
loud speaker system.
Connect the subwoofer speaker+ lead to the + terminal and the subwoofer
spakerlead to the terminal.
Note: Mono mode is designed for 2-8 ohm loads. If connecting two
subwoofer speakers, the unit will not support a 1 ohm load.
Connect two Subwoofer Systems:
Connect the two pairs of output terminals to corresponding subwoofer speakers:
Output connection:
Connect one Subwoofer System:
1st speaker connection:
2nd speaker connection:
TROUBLE SHOOTING
No Audio
- Low or no remote turn-on voltage: check remote connections at the amplifier and source unit.
- Blown amplifier fuse: replace with a new fast-blow fuse (same rating).
- Power wires not connected: check battery and ground wiring at the amplifier and check the battery connections.
- Speaker leads shorted: check speaker continuity to ground; it should not show a common ground.
- Speakers not connected or are blown: check speaker connections at the amplifier; measure coil impedance.
Distorted audio
- Gain is not properly set or the speaker cones are damaged.
- Review the instructions for setting the gain. Inspect each speaker cone for signs of damage, such as a frozen cone, burning smell, etc.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>