COOKING SURFACE Invisible Induction Cooking System Owner’s Manual

: September 29, 2024
: COOKING SURFACE

Table of Contents

Invisible Induction Cooking System
Product Information
Specifications:
Product Usage Instructions:

Invisible Induction Cooking System

Product Information

Specifications:

Brand: Surface Prime
Model: Push Control
Installation: Countertop

Product Usage Instructions:

1. Surface Preparation:

Place the transparent double-sided tape at the base of the
support surface of the control as shown in figure 1.

2. Installing the Control:

Present the Cooking Surface induction hob control on the
support surface, passing the cable through one of the sides of the
hob, and taking it out through the opening on the back.
Place the upper cover of the Push Control and screw in the four
supplied side screws.
Remove the protective paper from the double-sided tape and fix
the control in its correct position.

3. Additional Trims:

If you want to use one of the supplied trims, remove the paper
from the sticker and place it on the front panel of the system as
shown in figure 4.

4. Final Installation Steps:

Clean the lower part of the worktop where the Push Control will
be installed with solvent to improve the grip of the double-sided
tape strips.
Present the Push Control under the worktop and verify that the
system is extracted correctly and is perfectly centered and flush
with the hole in the profile, furniture, or mitered edge made for
its purpose.
Mark its outline on the lower part of the porcelain tile with a
marker to have the reference of the correct location.
Place the supplied double-sided tape strips on the contact fins
and fix them to the worktop starting from the marks previously made
for reference.

FAQ (Frequently Asked Questions):

Q: Can I adjust the height of the Push Control?

A: Yes, you can adjust its height by placing appropriate size
wooden slats under the countertop and screwing the system directly
to the slats through the holes provided in the countertops contact
wings.

DIMENSIONS:
NOTE: If the Push Control does not require installation directly on the porcelain or you need to adjust its height, you can adjust it by placing the appropriate size wooden slats under the countertop, and screwing the system directly to the slats through the holes provided in the countertops contact wings.

SYSTEM INSTALLATION MANUAL
SURFACE PRIME
cookingsurface.it

Place the transparent double-sided tape at the base of the support surface of the control as shown in figure 1.
F ig ure Present the Cooking Surface induction hob control on the support surface, passing the cable through one of the sides of the hob, and taking it out through the opening on the back. See figure 2.

Place the upper cover of the Push Control and screw in the four supplied side screws as shown in figure 3.
F ig ure Remove the protective paper from the double-sided tape in point 1 and fix the control in its correct position.
If you want to use one of the supplied trims, remove the paper from the sticker and place it on the front panel of the system as shown in figure 4.

Clean the lower part of the worktop where the Push Control will be installed with solvent to improve the grip of the double-sided tape strips.
Present the Push Control under the worktop and verify that the system is extracted correctly and is perfectly centered and flush with the hole in the profile, furniture or mitered edge made for its purpose. Mark its outline on the lower part of the porcelain tile with a marker to have the reference of the correct location.
To finish, place the supplied double-sided tape strips on the contact fins as shown in figure 5, and fix them to the worktop starting from the marks previously made for reference.

F ig ure