Reality R62171930 Monte LED Light Instruction Manual
- September 28, 2024
- Reality
Table of Contents
Reality R62171930 Monte LED Light
WARNING! Before assembling, please read carefully the safety instructions!
Reality Leuchten GmbH
TRIO International GmbH
Gut Nierhof 17
D-59757 Arnsberg
www.reality-leuchten.de
Instruction
This product contains light source(s) of energy efficiency class(es) F.
Description of how the light works without the remote control unit
If the lamp is switched on again via the main switch/wall switch after more
than 1 minute, the lighting scenario last set with the remote control is set
(memory function).
If the lamp is switched off using the remote control and switched on again
using the main switch/wall switch, the dimmer switch function comes into
effect at the warmest light color by quickly switching it off and on again
using the wall switch:
Brightness 100% 3000K
Brightness 50% 3000K
Brightness 25% 3000K
You can select it, with short turn on and turn off of the lamp.
Description of how the light works with the remote control unit
The most recently configured light settings is always displayed (memory
effect)
The synchronous control of several lights is not foreseen.
Operation of the remote control
- 1. Off
- 2. On
- 3 & 4. Brightness regulator: The adjustment takes place in stages. By pressing for a short period, it is possible to control the individual stages. Pressing the button permanently results in the maximum or minimum brightness being reached.
- 5 & 6. Light color: The regulation takes place in stages. The individual levels can be controlled by briefly pressing the button. The warmest or coldest color setting is reached more quickly by pressing the key continuously.
- 7. Mode: Cyclical modes switch
- Step: 3000K/
- Step: 4200K/
- Step: 6500K/
- Step: Night light
- 8. Night light
Set up remote control
Please disconnect the light from the mains for 10 seconds. Then switch the light on using the wall switch and at the same time press the “ON” button on the remote control. After about four seconds, the light confirms the successful programming by flashing several times. Now the light can be controlled with the remote control. The disengaging of the remote control works in the same way, except that the “OFF” button must be pressed instead of the “ON” button.
Declaration of Conformity
Hereby, Reality Leuchten GmbH. Gut Nierhof 17, D-59757 Arnsberg, declares that
this product is in compliance with Directive 2014/53/EU. The full text of the
EU declaration of Conformity is available at the following internet address:
https://files.trio-lighting.com/ce-conformity/R62171930.pdf