mitoredlight MitoHYDRO Hydrogen Water Bottle User Manual
- September 25, 2024
- mitoredlight
Table of Contents
MitoHYDRO Hydrogen Water Bottle
Specifications:
-
Product Name: MitoHYDRO
-
Hydrogen Content: Exceeding 800ppb
-
Hydrogen Concentration: Up to 5000ppb after 10 minutes of
operation -
Charging: USB magnetic suction head
-
Operation Time: Up to 10 minutes per session
Product Usage Instructions:
Quick Start:
1. Remove MitoHYDRO from the packaging box.
2. Disassemble the bottle:
-
Twist the cap counter-clockwise to unlock and remove the
bottle. -
Twist the glass from the generator to detach it from the
generator. -
Remove the clear plastic cap covering the electrode plate.
3. Hand wash the bottle and cap.
4. Remove clear protection film from the top and front of the
bottle.
5. Fill the bottle with water to the top of the colored section
near the threads.
6. Press the start button near the front bottom of the
bottle:
- Press once for 5 minutes of hydrogen production.
- Press twice for 10 minutes.
7. Listen for the beep once the timer ends, then drink and
enjoy!
Charging:
1. Ensure all parts and cables are dry before charging.
2. Connect the device to the power supply.
3. Wait for the blue light to illuminate on the USB magnetic
suction head.
4. Attach the USB magnetic suction head to the cup holder
magnetic suction head.
5. The display will indicate that charging has started.
6. Once fully charged, disconnect the power source.
Cleaning and Maintenance:
Washing the Generator:
– Clean the outside of the bottle with a wet wipe, avoiding
direct contact with water.
Cleaning the Air Vent:
– Regularly clean the air vent to prevent mineral buildup, which
can reduce airflow.
– For stubborn mineral buildup, dissolve 5 grams of citric acid
powder in warm water and soak the bottle for 30-60 minutes before
rinsing.
Safety Precautions:
– Avoid repeated hydrogen generation to prevent excessive
pressure buildup and lid seal issues.
– Contact customer service if lid remains stuck rather than
attempting to handle it yourself.
FAQ:
Q: Can I operate the MitoHYDRO for more than 10 continuous
minutes?
A: No, operating for more than 10 continuous minutes may cause
excessive pressure buildup. It is recommended to follow the
specified time limits for safe usage.
Q: How should I clean mineral buildup in the air vent?
A: To clean mineral buildup, dissolve 5 grams of citric acid
powder in warm water, soak the bottle for 30-60 minutes, then rinse
thoroughly after a 5-minute session.
USER MANUAL
MitoHYDRO
www.mitoredlight.com
© 2024 Mito Red Light, Inc. All rights reserved.
CONTENTS
Introduction ………………………………………………………………………………………………….. 03 Instructions
……………………………………………………………………………………………………. 04 Precautions
…………………………………………………………………………………………………… 06 Specifications and disposal
…………………………………………………………………. 07 Cautions and disclaimer
……………………………………………………………………….. 08 Warranty and maintenance
………………………………………………………………… 09 About us
…………………………………………………………………………………………………………… 10
INTRODUCTION
Water with a hydrogen content exceeding 800ppb is referred to as hydrogen-rich
water. Molecular hydrogen comprises the smallest molecules found in nature.
This molecular hydrogen is exceptionally permeable, swiftly absorbed by the
human body via the respiratory tract, bloodstream, skin, and digestive system.
When the hydrogen water bottle is filled and operates for 5 minutes, the
concentration of hydrogen molecules in the water can reach approximately
2000ppb. After 10 minutes of operation, this concentration can increase to
about 5000ppb. Continuous operation may loosen the bottle lid when the bottle
is full. Do not operate for the bottle for more than 10 continuous minutes as
it may cause excessive pressure buildup.
To ensure safe handling, always follow the instructions provided in the
manual. Do not attempt to perform repairs to the bottle yourself.
www.mitoredlight.com
3
INSTRUCTIONS
This package includes: A – User manual B – MitoHYDRO bottle C – Charging cable
Quick start: Remove your MitoHYDRO from the packaging box. Disassemble the
bottle: – Twist the cap counter-clockwise to unlock and remove the bottle. –
Twist the glass from the generator to detach it from the generator. – Remove
the clear plastic cap that is covering the electrode plate.
Hand wash bottle and cap. Remove clear protection film from the top of the bottle and the front of the bottle. Once your bottle is fully charged, fill your bottle with water to the top of the colored section near the threads. Then press the start button near the front bottom of the bottle. Press once for 5 minutes of hydrogen production, or twice for 10 minutes. Listen for the beep once the timer has ended then drink and enjoy!
4
www.mitoredlight.com
INSTRUCTIONS
Charging
Ensure the water bottle and all parts and cables are dry. Then connect the
device to the power supply. Wait until the blue light illuminates on the USB
magnetic suction head. Attach the USB magnetic suction head to the cup holder
magnetic suction head. The display will indicate that charging has commenced.
Once fully charged, the battery symbol will remain constant. At this point,
disconnect the power source.
Washing the generator
You can clean the outside of the hydrogen water bottle with a wet wipe, but
avoid washing it with water. If the power connection part becomes wet, ensure
it is thoroughly dried before charging again.
Cleaning the air vent
Note: Prolonged use may cause a buildup of minerals in the air vent, leading
to reduced air flow. It’s important to clean it regularly.
If mineral buildup is stubborn, dissolve 5 grams of citric acid powder in warm
water and soak the bottle for 30-60 minutes. After Soaking, begin a 5 minute
session. Once timer goes off, dump out the water and wash the bottle.
WARNING: Avoid excessive pressure buildup and lid seal issues by refraining
from repeated hydrogen generation. If unintentionally repeated, allow
sufficient time before attempting to open the bottle. If the lid remains
stuck, contact customer service rather than attempting to handle it yourself.
5
www.mitoredlight.com
PRECAUTIONS
Before initial use, fill the hydrogen water bottle with pure water and connect
it to the power supply to charge the generator. Once fully charged, switch on
the hydrogen production.
Use ONLY clean water. The water source quality must be “Drinking Water
Hygienic Standard”. Optimal choices include bottled mineral water, pure water
from household purifiers, or cold boiled water. DO NOT use fruit juices or
other chemical solutions to maintain hydrogen production efficiency and
prevent damage to the bottle.
Ensure the water temperature during operation remains below 60°C.
Hydrogen dissipates quickly in water, so it’s advisable to consume the
produced water immediately.
If white crystalline particles accumulate in the water after prolonged use,
soak the bottle in warm white vinegar or citric acid solution (heated to
around 40 ) for 60 minutes. Then, rinse the bottle thoroughly with clean
water.
Store the hydrogen water bottle with a small amount of water in the generator
in a cool place when not in use. Before using it again, empty the water from
the generator and clean it.
Keep the magnetic suction head clean, preferably by wiping it with alcohol.
In case of malfunction, refrain from disassembling the hydrogen water bottle
on your own. Instead, seek professional assistance.
www.mitoredlight.com
6
SPECIFICATIONS AND DISPOSAL
Name Model Capacity Net weight Size Electrode material Membrane Main unit material Working time Battery type Battery capacity Charging input
Hydrogen water bottle MitoHYDRO 230ml 368g
60mm*190mm Platinum titanium alloy Proton exchange membrane
Food grade PC 5 minutes/10minutes Lithium polymer battery
3.7V/1500mAh 5V 1A
Disposal
Before disposing of the appliance, remove the battery from the device by
following these steps: tear off the bottom pad, unscrew the bottom cover
plate, and carefully extract the battery, ensuring to avoid short-circuiting
the positive and negative poles.
Ensure the appliance is powered off before removing the battery, and dispose
of it safely.
7
www.mitoredlight.com
CAUTIONS & DISCLAIMER
Disclaimer
The statements in this manual have not been evaluated by the Food and Drug
Administration (FDA). The information provided is not intended to diagnose,
treat, cure, or prevent any disease and should not be construed as medical
advice. Our products are low-risk, general wellness / fitness products that do
not require FDA clearance, in accordance with the “General Wellness: Policy on
Low Risk Devices” draft released January 20, 2015.
Mito Red Light makes no claims or representations or otherwise warranties
regarding the ability of this product to cure any physical or mental
conditions. A qualified health professional should always be consulted prior
to using this product in regards to any condition that may requires medical
attention.
www.mitoredlight.com
8
WARRANTY AND MAINTENANCE
Under normal use this product is guaranteed for 1 year after its original
purchase date against manufacturing defects in materials or workmanship. This
warranty extends only to the original purchaser. If the product should become
faulty within the warranty period, contact Mito Red Light. Mito Red Light
reserves the right to repair a defective product. Mito Red Light reserves the
right to replace a defective product with the most compatible product
currently available.
This warranty does not cover damage caused by the following: – Accident,
misuse, abuse or alteration – Servicing by unauthorized persons -Connection to
incorrect power sources -Use with unauthorized accessories
Mito Red Light shall not be responsible for any incidental, special or
consequential damages resulting from the use of this product.
MAINTENANCE
This device has no serviceable parts. The battery is not accessible and not
serviceable. Users should not attempt to access or service the battery as this
will damage the device and void the warranty. Device includes only an ON/OFF
button. All settings are set to the factory setting. Charge the device only
with the supplied USB-C power charging cord and a universal USB-C power
adapter (not included). The battery capacity grid will begin to flash when
battery levels are low. This indicates the device should be recharged. The
lifetime of the Lithium lon Battery can be maximized by allowing it to fully
charge and then fully discharge during regular use.
9
www.mitoredlight.com
ABOUT
Located in Scottsdale, Arizona, Mito Red Light Inc is dedicated to bringing
the highest powered, highest quality red light therapy lights to market at the
best possible value. Having extensively studied and realized the benefits of
red light therapy firsthand, Mito Red Light was brought into existence in
order to provide consumers truly affordable, yet highly effective red light
therapy options.
If you have any further questions, please feel free to contact us at:
info@mitoredlight.com
You can also call our phone number Monday – Friday 9am – 5pm MST 1 (866) 861-
MITO
Mail correspondence can be sent to: Mito Red Light, Inc 9319 N 94th Way, Suite
400
Scottsdale, AZ 85258
www.mitoredlight.com
10
www.mitoredlight.com
User Manual and Instructional Videos This user manual and instructional videos
can be found here:
https://mitoredlight.com/pages/user-manual
Updated June 2024
6
www.mitoredlight.com
/mitoredlight
/mitoredlightofficial
@MitoRedLight
@mitoredlightofficial
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>