Puig REF 21044N Harley Davidson Instruction Manual
- June 3, 2024
- Puig
Table of Contents
PROTECTOR MOTOR
ONLY COMPATIBLE WITH MIDDLE CONTROLS)
REF 21044N Harley Davidson
Instruction Manual
INSTRUCTIONS TO ASSEMBLE
Remove the fasteners that subject the chassis to the engine. Mount the
protectors on each own side as the figure below shows. Tight the set, and
place the caps. All the screws replaced, should be tightened to the torque
specified in the oem maintenance manual for your motorcycle. if no torque
specifications are provided in the oem maintenance manual, may be used 54Nm
for all M10 screws.
Medium strength liquid thread-locker (i.e. “Loctite”) should be used to secure
all screws, bolts and nuts. All screws, bolts and nuts should be checked after
driving the first 50 km to ensure that all are tightened to the proper torque.
FOR TO ASSEMBLE THE CRASH PADS, IF YOU ARE NOT A TRAINED MECHANIC, PLEASE
CONTACT A SPECIALIST. MOTOPLASTIC, S.A. TAKES NO
RESPONSIBILITY FOR DAMAGES CAUSED BY IMPROPER INSTALLATION. THE USE OF CRASH
PADS DO NOT GUARANTEE A FULL PROTECTION IN CASE OF ACCIDENT. MOTOPLASTIC-PUIG
DECLINE ANY RESPONSIBILITY IN CASE OF MOTORCYCLE DAMAGE.
Accessory verified in the basic configuration of the motorcycle. For models
with extra factory settings. We cannot assure its compatibility, except for
prior consultation. We decline any eventual claim.
| ID. | PART | DESCRIPTION | QTY. | REF.: |
|---|---|---|---|---|
| 1 | Crash bar | 1 | PM0004N | |
| 2 | Nylon protector | 2 | CRASHPADCUSTOM | |
| 3 | M10/150×20 DIN912 screw | 2 | M2TM10150020A9B | |
| 4 | M10 DIN125/A washer | 6 | M2AM10DIN125AZB | |
| 5 | M10x25 DIN912 screw | 4 | M2TM10150020A9B | |
| 6 | Rubber trim (Accessory not included) | 2 | REF.3667 |
DISASSEMBLY
ASSEMBLY
www.puig.tv
www.puigusa.com
info@puig.tv
info@puigusa.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>