heater shop A-FRM1195B Blue Satin Towel Rail Installation Guide
- June 3, 2024
- heater shop
Table of Contents
A-FRM1195B Blue Satin Towel Rail
Installation Guide
A-FRM1195B Blue Satin Towel Rail
This product must be fitted only by a fully qualified installer.
DESCRIPTION
RADIATOR x 1
END PLUG x 1
|
RADIATOR BRACKETS x 4
---|---
AIR VENT x 1
|
WALL ANCHORS x 4
|
RAD. SCREWS x 4
| DESCRIPTION | ILLUSTRATION |
|---|---|
| Fixing choose the appropriate fixing for the wall material if required | |
| PTFE tape | |
| Electric drill | |
| Masonry drill bit appropriateto the fixings | |
| Adjustable spanner | |
| Radiator valve hex key | |
| Flat head and philips head screw drivers | |
| 1 lock shield valve and 1 gate or thermostatic valve | |
| Spirit level | |
| Measuring tape |
GENERAL RECOMMENDATION
- Before fitting the radiator it is necessary to wash out the heating system to remove any existing mud, scale, work residues, traces of flux, oil, etc.
- When the system water pH is outside the 5,5-8,5 range and/or when the dissolved is above 0,1mg/liter, it is always needed to protect the heating system components (the radiator is one of these) with a proper chemical treatment compatible with all parts in contact with water (silicon rubber too).
- In order to fit the radiator to the wall, it is necessary to choose the proper fixings for the wall material.
- If the system water exceeds 50°C, please install a warning mark near the radiator to avoid any accidental scalding.
- Maximum working temperature 95°C, maximum working pressure 4 bar.
- Clean the radiator surface only with a soft cloth to avoid scratching the finish and do not use chemical agents during cleaning operations. It is prohibited to climb on the radiator.
| 1 | RADIATOR |
|---|---|
| 2 | RADIATOR BRACKET |
| 3 | WALL SCREW |
| 4 | WALL ANCHOR |
| 5 | WALL |
| NAMES | A |
| --- | --- |
| FERMO | 710 |
| FERMO | 1190 |
| FERMO | 1550 |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>