UIC UXG-Max Gateway User Guide
- September 23, 2024
- UIC
Table of Contents
**UIC UXG-Max Gateway User Guide
**
Compact security gateway designed to protect small to medium-sized networks with enterprise-class rewall configuration and threat management features.
Mechanical
| Dimensions | 141.8 x 127.6 x 30 mm (5.6 x 5 x 1.2″) |
|---|---|
| Weight | 520 g (1.1 lb) |
| Enclosure material | Polycarbonate |
| Resistance | IK04 |
Hardware
| Processor | Quad-core ARM® Cortex® -A53 at 1.5 GHz |
|---|---|
| Memory information | 2 GB DDR4 |
| Management interface | Ethernet Bluetooth |
| Networking interface | (4) LAN: 2.5 GbE RJ45 ports (1) WAN: 2.5 GbE RJ45 port |
| Power method | USB type C (5V/3A) |
| Supported voltage range | 100–240V AC |
| Max. power consumption | 9.6W |
| LED | Status: white/blue |
| Button | (1) Factory reset |
| Operating temperature | -10 to 40° C (14 to 104° F) |
| Operating humidity | 5 to 95% non condensing |
| Certifications | CE, FCC, IC |
Compliance
FCC
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions.
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This radio transmitter FCC ID: SWX-UXGM has been approved by FCC.
ISED Canada
CAN ICES-3(B)/NMB-3(B)
This device complies with ISED Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
This radio transmitter (IC: 6545A-UXGM) has been approved by ISED Canada.
RF Exposure Warning
The antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be located
or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>