SUPERSONIC SC-1423SB Portable Bluetooth Sound Bar User Manual
- September 20, 2024
- Supersonic
Table of Contents
SUPERSONIC SC-1423SB Portable Bluetooth Sound Bar
Specifications
- Bluetooth: Version 5.3
- Battery: 3. 7V 1200mAh
- Charge voltage: 5V 800MA
- Loudspeaker size: 52MM, 452, 10W(5W*2)
- Passive Radiator: 4080 *2SETS
- Charging time: Around 2 hours
- Playback time: 2-5 hours
- Working range: No less than 10M (free space)
Buttons on the Sound Bar
- MODE CHANGING (Short Press)
- VOLUME DOWN (Long Press), or PREVIOUS SONG (Short Press)
- PLAY / PAUSE (Short Press)
- VOLUME UP (Long Press), or NEXT SONG (Short Press)
- ANSWER / END THE CALL(Press Once), REDIAL (Press Twice)
- AUXINSLOT
- HDMI with ARC PORT FOR MUSIC PLAYING
- TF CARD SLOT
- CHARGING LED LIGHT(RED), or MODE INDICATION(BLUE)
- DC IN SLOT FOR CHARGING
- ON/OFF SWITCH
Features
Flashing indications
Bluetooth mode:
- Bluetooth waiting for pairing, Blue led fast flash
- Bluetooth paired, Blue led constant, Slow Flash against BT playing music
- TF card mode: Blue led slow flash
- Aux in mode: Blue led slow flash
- HDMI FM mode: Blue LED slow flash
- FM Radio Mode: Scan channels: blue led fast flash; Playing channels- blue led constant;
- Red led constant while charging, red led off while fully charged
- Bluetooth Pairing
- Short Press” key to Bluetooth mode, the blue LED will keep fast flashing
Follow the operating instructions of your Bluetooth device and allow it to search Bluetooth state, after a few seconds your mobile will discover the Bluetooth Soundbar under “SC-1423SB” Select this and your device will confirm this pairing. You can start playing music through the Soundbar. Enter password or PIN 0000 on our Bluetooth device (if necessary), and press “Yes” or “Confirm”.
Important notice: If the connection is successful, the lue LED keeps ca onstant, slow flash while playing music.
Bluetooth Hand-free: Work with Bluetooth for wireless communication.
TF card mode:
- Insert the TF card (MICRO SD) to play music
- Built-in MICRO SD smart decoder, you can listen to music stored in
- TF card supports MP3/ WMA format, and MAX 32GB.
AUX mode:
Insert one end of the 3.5MM audio cable into the speaker; plug the other end
into any compatible device (Mobile phone/MP3, compute,r, etc.) to play music.
HDMI mode:
Insert the HDMI Cable to play music.
PS : Make sure your HDMI output with ARC function
FM Radio Mode
Use your charging cable as an antenna cable and insert ert into the Soundbar,
Press the mode button until you hear “FM mode”. Then Long press the 2-3
Seconds “Pause” button to scan and load all FM radio stations within range.
Once it stops scanning, you can\ switch stations by pushing the Vol. up or
down buttons. Long press the Vol. up or down button to change the volume,
until the volume reaches the desired level.
WARRANTY
Supersonic Inc. (“Supersonic”) warrants this product to the original purchaser ONLY, to be free from defects in materials and workmanship under normal use, for ninety (90) DAYS from the date of original purchase. Proof of purchase (receipt) is required. Please visit https://www.supersonicinc.com/pages/warranty for additional information.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interfer ence received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to protect reasonably against harmful interference in a residential installation. This equipment generates, uses, and can radi ate radio frequency energy and, if not installed and used by the instructions, may ca use harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is e ncouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements in
portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>