SANWA MA-ERGBT11N Ergonomic Silent Mouse User Manual

SANWA MA-ERGBT11N Ergonomic Silent Mouse User Manual

Bluetooth Mouse
MA-ERGBTI IN / GMAERGBTI I N
FCC ID: 2AMSUGMAERGBT11
DID: D036462

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

1. Opening

Thank you for purchasing this Ergonomic Mouse.

2. Caution

• The company is not liable for any damages, such as live motion defects, data loss, etc., caused by using this product or software.
• This product is not guaranteed to be compatible all devices.
• This product is intended for use in general workplaces and homes. The company does not assume responsibility in the event of damages caused by using in any other places.
• Refrain from using in environments where medical instruments and systems directly or indirectly related to human life are required, and where a high level of safety and responsibility is required.
• Refrain from using directly or indirectly with equipment and computer systems in which a high level of safety and responsibility are required.
• Do not use this product on airplanes as it may interfere with the airplane communication system.
• Please consult your doctor before using this product if you use a pacemaker or other medical device.

3. Warnings Regarding Health

Operating the mouse, trackball, and keyboard for long periods of time can lead to pain or numbness in hands, arms, neck, shoulders, etc. Serious damage may be incurred if such use is repeated. If you feel pain or numbness while operating the mouse or keyboard, stop using it immediately and consult a doctor if necessary. Take regular breaks from daily computer work to avoid strain on hands, arms, neck, shoulders, etc.

4. Specifications

5. Compatible Models

Windows (DOS/V) PC / tablet, Apple Mac series, Chrome OS PC, Android smartphone / tablet, iPhone series, iPad series
For Mac series, side buttons cannot be used.
Models that support a Bluetooth mouse with a built-in Bluetooth module.
*Models that support Bluetooth 3.0 HID.

6. Compatible OS

• Windows 10, 8.1 macOS I macOS 10.1 Mac OS X IO.FIO.I
• Chrome OSs I x iOS13• iPadOS

7. Name of Parts

8. How to Insert Batteries

Insert the supplied AAA batteries into the battery compartment slot.
Insert the electrode end first, then insert the body.
*Be careful of polarity when inserting batteries.

Before using it for the first time, please make sure there is battery power remaining.
Replace batteries when the movement of the mouse cursor becomes rough, or when the blue LED sensor does not turn on.
Turn off mouse when replacing batteries.
Use new AAA alkaline batteries when replacing batteries.
*Leaving expired batteries in the mouse may result in leakage; be sure to remove batteries when expired.

9. Pairing Operation

(Initial Pairing Method)
When the power switch on the underside of the mouse to turned to ON, the LED on the side of the mouse will flash red for 3 seconds.
(If other devices have been paired previously, it will connect automatically at this point.)

Next, push the Pairing button on the back of the mouse to enter pairing mode. When pairing mode is entered, the LED on the side of the mouse will flash red quickly. On the device, the model name “MA-ERGBTI 1 N” will be displayed under the device name to indicate that pairing with the device is complete. Once pairing is complete, the LED on the side of the mouse will flash red for three seconds, then turn off.

(After Pairing Operation is complete)
When the mouse’s power switch is turned on, the connection will be made automatically.

10. Sleep Mode

The mouse will turn into sleep mode if not being used for a while, even if the power switch is ON.By clicking the mouse, it will come back to work from the sleep mode.
Sometimes, however, the mouse may become unstable when suddenly being operated.

11. Customize Buttons (Windows only)

Once you download the driver software from the website, you can use
the button programming function.

*To use custom keystrokes, you need to keep the software enabled.

1. https://www.sanwa.com/download/mu.exe
   Please access. The download will start as soon as you access it.

2. Save and open the file.

3. Please follow the installation wizard to install the driver.

In the process of installation or use of any problem, please contact us.
You can also refer to this document.
https://www.sanwa.com/download/mu.pdf

12. Troubleshooting

Q. Mouse (mouse cursor) doesn’t move.
A. 1. Check to make sure the pairing has been severed. (see “9. Pairing Operation”)
2. Make sure that the batteries have been correctly inserted.
Make sure that the mouse’ power has not been switched to OFF. (see “8. How to Insert Batteries”)
3. The battery level may be low; try replacing the battery. (see “8. How to Insert Batteries”)

Q. If the mouse is not moved for some time, it takes a few moments to start up. The mouse (mouse cursor) doesn’t move.
A. If the product is not moved for some time, it enters sleep mode to conserve the battery. Pressing the button on the mouse will restore movement, but it will take a few seconds.

Q. The mouse cursor movement is not smooth.
A. Although the blue LED is a high performance sensor, there are times when the cursor does not move smoothly when used on a surface that reflects light, such as a mirror, or a transparent surface such as glass. Also, the tracking performance may degrade on regularly patterned surfaces.

13. Warranty Term

1 year

14. Inquiries

EN : support-en@sanwa.com

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>