LEDWOOD XTREME200 BT Portable Speaker User Guide
- September 18, 2024
- LEDWOOD
Table of Contents
XTREME200
BT Portable Speaker
User Guide 200W (2x10w PMS)
XTREME200 BT Portable Speaker
SAFETY INSTRUCTIONS
Please read this manual carefully, as it contains important information
on the installation and use of the appliance.
- Make sure that the mains voltage is suitable for the appliance and does not exceed the supply voltage indicated on the rating plate of the appliance.
- To avoid the risk of fire or electric shock, do not expose the appliance to rain or moisture. Make sure that there are no flammable objects near the appliance during operation.
- Do not place naked flames on the appliance.
- The appliance is intended for use in a temperate climate. The ambient temperature must not exceed 40°C. Do not use the appliance at higher temperatures.
- In the event of malfunction, switch off the appliance immediately. Never attempt to repair the appliance yourself. Incorrect repairs may cause damage or malfunction. Contact an authorised technical service.
- Supervise children to ensure that they do not play with the appliance.
(INSTRUCTIONS FOR BUILT-IN BATTERIES
- Batteries should not be exposed to excessive heat such as sunshine, fire or the like. Risk of explosion, ignition and fire!
- Do not open the product
- Stay close to the during charging. In case of extreme heat, stop the process immediately and contact your dealer.
CLASS II EQUIPMENT!
- Safety extra low voltage (SELV) or protective power supply, earth not connected, safe power supply (safety transformer).
FEATURES
| Bluetooth | 5.0 |
|---|---|
| Max RF power | <100mW (5dBm) |
| Frequency | 85db |
| Impedance | 4Ω |
| Input power | 5V-1200mA |
| Bluetooth range | 10m |
| Power | 20W |
| Waterproofing | IPX5 |
| Total autonomy | 10h |
| Autonomy | 2h |
| Battery capacity | 1800 mAh |
CAUTION:
if the product is to be left unused for a long time, leave the battery
fully charged, otherwise the battery may be damaged !
Recharge the product at least every 2 months.
Do not expose your device to extreme temperatures (above 50°C) (e.g. direct
sunlight in a closed vehicle, near a heat source or radiator, etc.). High
temperatures can damage the speaker’s and reduce battery life.
- AUX 3.5 mm audio input
- USB input
- Reset
- USB-C power alimentation
CHARGING INSTRUCTIONS
- Connect the USB Type C cable to the « USB-C » connector (4), then to a USB socket or the mains supply via an AC adapter (not supplied). Once the battery is fully charged (approx. 5 hours), disconnect the cable.
- Press hold the main power button (7) to switch on the product.
| FUNCTION | PRESS THE KEY | BUTTON |
|---|---|---|
| ON / OFF | 7 | |
| Change light animation mode + Turn off lights. | 8 | |
| Switch between modes : USB / AUX / BLUET0011-1 | 9 | |
| 6 | ||
| 5 | ||
| 10 | ||
| 5 | ||
| 10 |
LEGEND
Long Press
Short Press
PAIRING AND BT CONNECTIVITY
- Press and hold the mains «POWER» button (7) to switch on the product.
- Activate the wireless audio function on your device (smartphone, tablet, etc.).
- Select «XTREME200» from the list of devices found.
(Note: the product automatically enters Bluetooth mode when switched on).
TWS FUNCTION
- Switch on both speakers and press the « TWS » (11) button on one of the speakers. The TWS button will continue to light up after successful pairing.
- Activate your phone’s Bluetooth function and search for the pairing name. Establish the connection.
- Press the « TWS » (11) button to disconnect the TWS function.
3.5MM AUXILIARY CONNECTIVITY
Connect a 3.5mm AUX jack cable to the « AUX » input (1), the speaker will
automatically play the music USING USB
RGB LIGHT
Insert a USB key in the « USB » slot (2), the speaker will automatically play
the music
The RGB light is on when the speaker is switched on. Simply press the «RGB»
button (8) to switch the light on/off.
HANDS-FREE FUNCTION
Incoming call: Briefly press the «Play/Pause» button (6) to accept the
call, or press and hold to reject the call.
End call: Briefly press the « Play/Pause» button (6) or operate the cell phone
to end the call.
Nous, SAS CHURCHILL, 20 rue St Gilles – 75008 Paris – France
Certify and declare under our sole responsibility only the following products:
Brand : LEDWOOD
Type or model : XTREME 200
Factory model number : ES10R
Designation : Systeme de sonorisation amplifire
Is compiles with the directive :
2014/53/UE
A full compliance statement is available by download or email at:
direction@churchill.world
www.ledwood-audio.com
SAS Churchill – 20 rue Saint Gilles
75003 PARIS – FRANCE www.ledwood-audio.comhttps://www.ledwood-audio.com/
Download the instructions in .pdf format
contact us via the mail below:
contact@sav08.fr
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>