GE 18279 Indoor Wireless Wall Switch Lighting Control Instruction Manual

GE 18279 Indoor Wireless Wall Switch Lighting Control

ENCLOSED YOU WILL FIND

• Receiver
• Wall Switch Remote Transmitter
• ( 1) 12V A23 Battery ( installed)

OPERATING INSTRUCTIONS

1. Plug Receiver into a standard indoor outlet.
2. Plug device to be controlled into the outlet on the Receiver:
3. Make sure outlet supplying Receiver is powered.
4. Make sure lamp or device is turned ON.

IMPORTANT: The device will remain OFF until the Receiver is activated by the Transmitter.

REMOTE INSTRUCTIONS
Open the battery comportment on the transmitter and remove the battery saver insert.
You con now control your device remotely using the Remote Transmitter: A light on the Receiver turns on when the unit is activated remotely, indicating that power is being supplied to the lamp or device.

REPLACING BATTERY

1. Remove bock battery cover.
2. Remove old battery.
3. Install new 12V type A23 alkaline battery, noting polarity.
4. Replace battery cover.

TROUBLESHOOTING
If indicator light is not activated by pressing the switch …

1. Make sure switch is depressed and held for at least 1 second.
2. Verify battery orientation, noting polarity
3. Replace the battery (USE ONLY 12V type A23 Alkaline).
4. Place the switch in a new location.

FOR INDOOR USE ONLY

CAUTION: DO NOT EXCEED ELECTRICAL RATINGS

RECEIVER

• Functional Ronge ___ ,up to 100ft
• Maximum Resistive Load ___ 1440W
• MaximumTungsten Load___ 360W
• Rating ___ 12A / 120V / 60Hz

WALL SWITCH TRANSMITTER

• Functional Ronge ___ up to 100ft
• Battery Type ……………………….. Use only 12V Alkaline A23

Functional range may be adversely affected by one or more of the following factors: weather, radio frequency interference, low transmitter battery and obstructions between the transmitter and receiver.
This device complies with port 15 of the FCC rules.

Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

FCC NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.

This equipment hos been tested and found to comply with the limits for a class B digital device, pursuant to port 15 of the FCC Rules. These limits ore designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and. if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However. there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Compliance with IC Rules and Regulations

• IC 18279
• Company: Josco Products Company
• Model Number 18279

Object is subjected to the following two conditions.
This device may not cause interference, and this device must accept any interference, including interference that may cause undesired operation of the device.

This class B digital apparatus complies with Canadian ICES-003.

WARNING
RISK OF ELECTRIC SHOCK

• FULLY INSERT PLUG
• KEEP CHILDREN AWAY
• USE INDOORS ONLY
• DO NOT USE IN WET LOCATIONS
• UNPLUG BEFORE CLEANING

RISK OF FIRE

• DO NOT EXCEED ELECTRICAL RATINGS
• DO NOT USE TO CONTROL MOTOR-OPERATED

APPLIANCES, TRANSFORMER-SUPPLIED
APPLIANCES OR APPLIANCES
THAT CONTAIN HEATING ELEMENTS (COOKERS, IRONS, HEATERS, ETC.)

BATTERIES MAY LEAK HARMFUL LIQUIDS OR IGNITABLE MATERIALS OR EXPLODE CAUSING INJURY AND PRODUCT DAMAGE

• DO NOT MIX OLD AND NEW OR OTHER BATTERY TYPES
• REPLACE ALL BATTERIES AT THE SAME TIME
• REPLACE FULLY DISCHARGED BATTERIES IMMEDIATELY

MADE IN CHINA
GE is a trademark of General Electric Company and is under license by Jasco Products Company LLC, 10 E. Memorial Rd .. Oklahoma City, OK 73114.
This Josco product comes with a 90-day warranty. Visit www.byjasco.com for warranty details.
Questions? Contact us at 1-800-654-8483 between 7:00 AM-8:00 PM CST.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>