TORQ TQAVR5KVA Automatic Voltage Regulator User Manual

TORQ TQAVR5KVA Automatic Voltage Regulato

FEATURES

Precut Peils and Devic6.

• Multiple Outlets Protect Peripherals and Devices.
• Automatically Regulating High Voltage and Low Voltage.
• Able to Reset Input Overload Protection Circuit Breaker.
• User-friendly LCD Display
• Selectable DelayTime Setting (2/10/30s).

SPECIFICATION

OVERVIEW

FRONT PANEL

1. AVR ON/ OFF switch: – AVR turn on & turn off
2. LCD Screen

REAR PANEL

1. AVR Regulated plus Surge Protection Outlets
2. Input Circuit Breaker Switch
   • Allow for easy recovery from an overload.
   • Allow to turn off AVR Input completely.
3. Internet, ADSL, Fax/Modem Protection
   • Protect your phone and data line from dangerous and costly lightning surges.
4. Soft Start (Delay Timer) Setting Switch :
   • To set different delay time with 2, 10 or 30 seconds per your demand.
5. Utility Power Input

INDICATION AND CONTROL

1. Delay Timer Count Down (T)
   • Delay time can be set as 2 seconds, 10 seconds, or 30 seconds. When the delay time is set as 2 seconds, the number above the “T” icon will count down from 2 to 0 after AVR is turned on. (If the delay timer is set as 10 sec., a number will count down from 10 to O…and so on) After the delay time is finished, the “T” icon will not be lit anymore and the “Normal” icon will be lit.
2. Delay Icon – Icon flashes once every second before the delay time countdown is finished.

INDICATION AND CONTROL

1. Display of input voltage
   • LCD will display input voltage after AVR is turned on.
2. Display of output voltage
   • LCD will display rating output voltage.
3. Normal Icon
   • Icon is lighted: AVR is under normal status and supplying utility power to loads.
4. Low Volt. Icon
   • Icon is lighted: Input voltage is too low and AVR output is cut off.
5. Boost Icon
   • Boost” is lighted : AVR is correcting a low utility voltage condition.
   • “1” icon is lighted: AVR is doing 1st step boost.
   • (If “2” icon is lighted, AVR is doing 2nd step boost…and so on)
6. Buck Icon
   • “Buck” is lighted: AVR is correcting a high utility voltage condition.
   • “1” icon is lighted: AVR is doing 1st step buck.
7. High Volt. Icon
   • Icon is lighted: Input voltage is too high and AVR output is cut off.
8. Overheat Icon
   • An icon is lighted: AVR is overheated, buzzer will beep continuously.
   • Please reduce load capacity
9. Overload Icon
   • The icon is lighted: AVR is overloaded, buzzer will beep once every 4 seconds.

Please reduce load capacity.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>