TORQ RAV-MLE1 Toyota Rav4 Front Molle Panels Instruction Manual
- June 1, 2024
- TORQ
Table of Contents
TORQ RAV-MLE1 Toyota Rav4 Front Molle Panels
Notice to Dealer / Consumer
Important! Read all instructions before attempting any work on the
vehicle.
Disclaimer Notice: Installing this suspension system on any vehicle
implies that you are in agreement with the following terms and conditions
concerning that vehicle, the vehicle owner, and any or all occupants of said
vehicle at any time:
- Torq Engineering is not responsible, and cannot be held responsible for any conditions of the said vehicle including, but not limited to the following: 1) any adverse behaviour, premature failure, or breakage caused by oversized tyres and wheels, improper installation, failure to follow instructions, or any general negligence caused by the installer or owner of said vehicle. 2) Any breakage or premature failure caused by racing or driver negligence. 3) Any incident determined to be caused by an increase in height in said vehicle’s centre of gravity. 4) Any incident determined to be caused by improper installation. 5) Any incident determined to be caused by a failure of materials.
- Torq Engineering is to be held harmless by the installer of this suspension component, the owner of said vehicle, and any parties related directly or indirectly to said vehicle or the owner of said vehicle. Torq Engineering is to be held harmless by all parties mentioned during any circumstances or incidents resulting from the installation of this suspension component.
- It is not the intention of Torq Engineering that said vehicle be modified for use on public highways sanctioned by the Department of Transportation, or any state or local governing body. The vehicle owner accepts sole responsibility for ensuring that said vehicle is not in violation of local, state, or federal laws or vehicle codes. Please check local vehicle laws and regulations before modifying your vehicle.
- By installing this kit or having this kit installed on your vehicle, you are implying that you agree to the above terms and conditions. Please do not install this system if you do not agree.
WARNING
Vehicles modified for Off-road use may handle differently and vehicles may
roll over. Vehicles modified for off-road are generally not designed to
improve cornering or maneuverability on the highway, therefore it is
imperative to familiarize yourself and all operators of the vehicle with the
special driving characteristics of the vehicle. Failure to operate a vehicle
safely and conservatively may cause you, your passengers and third parties to
suffer serious injury or even death if control is lost and the vehicle
overturns. Always wear your seatbelt and shoulder harness. Seatbelts not only
help to protect occupants from injury but also keep the driver behind the
wheel and in control when operating in rough terrain. Always remain on trails
and observe conservation techniques while operating your vehicle.
2019+ TOYOTA RAV4 MOLLE PANELS (FRONT)
Bill of Materials
INSTALLATION NOTES
- Inspect the contents of the kit and read the entire instructions before proceeding.
- We recommend this installation be performed by a qualified technician
- Torque all hardware to factory specifications
- We recommend using red Loctite on all bolts
Front Installation
- Align the Molle panel with the factory side panel and centre punch or mark the mounting holes.
- 5/16” Drill bit to redrill the holes.
- Insert Rubber Well Nuts
- Install the ½” Aluminum spacers behind the molle panel and secure using the M4 Button head bolts.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>