BESING T8 Bluetooth Earbuds Instruction Manual
- September 12, 2024
- BESING
Table of Contents
BESING T8 Bluetooth Earbuds
Please read the instructions before use
Connect
- Take out the earbuds (Earbuds auto power on)
- After open the phone Bluetooth, Click the < T8 > to Pairing
Reset
If there are connectivity or functional issues with the headset, please reset the headset:
- Delete Bluetooth pairing information on the device and turn off the device’s Bluetooth functionality.
- Put the headset into the charging box to charge.
- Turn on the Bluetooth function of the device.
- Take out the headset and wait for 20 seconds before pairing and connecting to the device again.
(If the above operation does not work, please try again)
Operation
Problem handling
-
Can be connected but there is no sound:
Long press the right ear + volume -
One of earbuds cannot be charge:
Clean the charging contacts of the headset and charging box. -
One of the earbuds cannot be connected:
Reset the earbuds(See page 2).
If the headset cannot be charged after activating the product (it is normally connected to the Bluetooth device for the first time), Contact us to send new products.
Please clean the charging contacts of the earbuds and charging case frequently to avoid charging failures.
Safety Instructions
Warning:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These Limits are
designed to provide reasonable protection against harmful uses and can radiate
radio frequency energy and, i not installed and used in accordance with the
instructions, may cause harmfut interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>