BESING TECHNOLOGY SHENZHEN CO LTD x35 Wireless Earphone Instruction Manual
- June 1, 2024
- BESING TECHNOLOGY SHENZHEN CO LTD
Table of Contents
Instruction Manual
Please read the instructions before use
Connect
- Take out the earbuds (Earbuds auto power on)
- After open the phone Wireless, Click the
to Pairing
Reset
if earbuds has any connection or function problems, please reset the earbuds
- Delete the Wireless pairing information on the phone.
- Put the earbuds into the charging case to charge.
- Take out the earbuds and wait for 20 seconds.
(If the above operation does not work, please try again)
Operation
X1: Click Once
X2: Click 2 times
2S: Press and hold for 2 seconds
Problem handling
-
Can be connected but there is no sound:
Click the right earbuds to increase the volume. -
One of earbuds cannot be charge:
Clean the charging contact of the earbuds and the charging case. -
One of the earbuds cannot be connected:
Reset the earbuds.
If the earbuds cannot be charged, please activate the warranty and contact us
to send a new product.
Please clean the charging contacts of the earbuds and charging case frequently
to avoid charging failures.
Made in China
Warning:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>