Besing Technology X15 True Wireless Earbuds Instruction Manual
- June 6, 2024
- Besing Technology
Table of Contents
Instruction Manual
X15
Please read the instructions before use
Before Use
- Fully charge the earbuds and charging case.
- Choose the right angle and eartips.
Connect
- Take out the earbuds (Earbuds auto power on)
- After opening the phone Bluetooth, Click the
to Pairing
Reset
If earbuds has any connection or function problems, please reset the earbuds
- Delete the BT pairing information on the phone.
- Take the earbuds into the charging case to charge.
- Take out the earbuds and wait for 20 seconds.
(If the above operation does not work, please try again)
Operation
X1: Click Once
X2: Click 2 times
2S： Press and hold for 2 seconds
Battery Indicator
| Pairing | Connected | Charging |
|---|---|---|
| Flashing | No Light | Red |
**** Wipe and dry charging contacts if earbuds can’t be charged.
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
NOTE: This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Statement: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.