Panasonic RI21A Highly Integrated Transceiver Module User Manual
- June 3, 2024
- Panasonic
Table of Contents
Panasonic RI21A Highly Integrated Transceiver Module
GENERAL
The RI20A is a highly integrated transceiver module for contactless reader/writer communication at 13.56 MHz.
Integration to the end product
- RI21A module is mounted in the Accessory FZ-VNF401.
- Insert Antenna unit into Antenna connectors of RI21A module.
Technical Specification
- Dimensions (H x W x D): 17.6mm x 40.15mm x 1.0mm
- Supported RF protocols : ISO/ IEC14443 Type A, Type B, and Felica
- Operating Temperature :-10 to 50 degree Celsius
- Host interface: Serial Peripheral Interface
Regulatory Information
Federal Communications Commission Radio Frequency Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that maycause undesired operation.
Caution Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Instructions to OEM Integrators
The following information must be indicated on the host device of this
module; Contains FCC ID : ACJ9TGRI21A, IC: 216H-CFRI21A This module is Part
15.225/RSS-210 limited module. The module is limited to be use by the grantee
in its own products, not intended for sale to third parties.
Antenna Information
Integral loop antenna is used. When the antenna is changed, additional test
and certification will be needed.
Additional testing, part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts
(i.e., FCC transmitter rules) listed on the grant, and the host product
manufacturer is responsible for compliance to any other FCC rules that apply
to the host not covered by the modular transmitter grant of certification. The
final host product still requires Part 15 Subpart B compliance testing with
the modular transmitter installed
Canada-ISED Canada
This device complies with ISED Canada’s license-exempt RSSs. Operation is
subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may causeundesired operation of the device.
Instructions to OEM Integrators
The following information must be indicated on the host device of this module;
Contains FCC ID : ACJ9TGRI21A, IC: 216H-CFRI21A
This module is Part 15.225/RSS-210 limited module. The module is limited to be use by the grantee in its own products, not intended for sale to third parties.
Antenna Information
Integral loop antenna is used. When the antenna is changed, additional test
and certification will be needed.