HYANKA ES-65 Car Coaxial Speakers Instruction Manual
- September 5, 2024
- HYANKA
Table of Contents
HYANKA ES-65 Car Coaxial Speakers
Specifications
| Feature | Description |
|---|---|
| Model | ES-65 Car Coaxial Speakers |
| Brand | HYANKA |
| amz@hyaudio.com.cn | |
| Website | HYANKA.COM |
FAQs
How do I know if the mounting location is suitable for the speakers?
A: Ensure that the area is large enough for the speaker to be evenly mounted and that the mounting location is deep enough for the speaker to fit. If mounting in a door, operate all functions (windows, locks, etc.) through their entire operating range to ensure there is no obstruction.
What should I do if the hole size is not suitable?
Refer to the specification chart to determine the correct hole diameter. If the size is not suitable, you can try to open the hole with a hole opener.
How do I connect the speaker wires correctly?
What is the correct way to tighten the screws?
Tighten the screws until the speaker is firmly in place to prevent rattling. Don't tighten the screws too much.
What are the wiring methods available?
There are two wiring methods: Method 1: Car Coaxial Speaker + Car Stereo Amplifier + Vehicle Mainframe Method 2: Car Coaxial Speaker + Vehicle Mainframe
A: There are two wiring methods:- Method 1: Car Coaxial Speaker + Car Stereo Amplifier + Vehicle Mainframe
- Method 2: Car Coaxial Speaker + Vehicle Mainframe
MOUNTING
- Determine where the speakers will be mounted. Ensure that the area is large enough for the speaker to be evenly mounted. Be sure that the mounting location is deep enough for the speaker to fit; If mounting in a door, operate all functions (windows, locks, etc.) through their entire operating range to ensure there is no obstruction.
- Refer to the specification chart to determine the correct hole diameter. If the size is not suitable, you can try to open the hole with a hole opener.
- Mark the locations of the mounting screws. Drill the holes with a 1/8”’bit.
- Feed the speaker wires through the cutout and connect to the speaker terminals. Be sure to observe proper polarity when connecting the wires. The speaker’s positive terminal is indicated with а “+”.
- Fit the trim ring over the speaker and mount using four screws.
- Tighten the screws until the speaker is firmly in place to prevent rattling. Don’t tighten the screws too much.
DESCRIPTION OF WIRING METHOD
- Method 1: Car Coaxial Speaker+Car Stereo Amplifier+Vehicle mainframe
- Method 2: Car Coaxial Speaker+Vehicle mainframe
Note: The left side of the speaker wire is positive and the right side is negative.