Aosom IN230500341V01 Ultimate Slope Side Snow Fun User Manual

Aosom IN230500341V01 Ultimate Slope Side Snow Fun

SAFETY INFORMATION

IMPORTANT INFORMATION INSIDE

• Read this User Manual carefully before using your winter product
• WARNING: CHOKING HAZARD – SMALL PARTS. NOT FOR CHILDREN UNDER (3) YEARS.

Adult Assembly Required

To Avoid Injury:

• Warning information in the User Manual, on the product and packaging must always be read before every use and explained to anyone using this product.
• This product is designed for use by a person seven years of age and above. Competent adult supervision is required.
• Do not leave children unattended while using this product.
• Use of this product and participation in this sport involve inherent risks of injury or death.
• Users MUST follow the instructions from the User Manual and the Warning at all times, improper use of this product will cause serious injury or death.
• This product must not be used by more than one (1) rider with a maximum weight of 88 lb (40kg) at a time. Do not exceed the recommended number of riders or weight capacity.
• Always wear protective equipment such as a helmet, goggles, and gloves.
• This product is designed with limited braking and steering. Be aware this product can develop at high speeds under certain snow conditions.
• The metal snow braking system does not allow for a quick shortstop. It is solely intended as a way to gradually reduce the downhill speed.
• DO NOT tow behind any motorized vehicle on land or snow; this is not a towable item.
• DO NOT tow behind any motorized vehicle or people when the rider is sitting on the product.
• Do not use on ski hills, icy surfaces, surfaces without adequate snow coverage, and obstructed or dangerous areas.
• Do not use this product near roads, trees, or other hazardous objects or conditions.
• Do not dive head first onto this product.
• Do not use this product while under the influence of drugs and alcohol.
• Keep control of your sled at all times. It is your responsibility to avoid people and objects in front of you.
• Always keep the rider positioned near the front for increased control and steering. As the body is shifted closer to the back the steering and control are reduced.
• Always replace the tow leash handle and the locking buckle to the front ski before every use.
• Use at your own risk.
• Do not use on steep slopes, only use on slopes with a low incline within your skill level.
• Do not operate with poor or limited visibility.

PARTS DIAGRAM

1. Front Nose
2. Wind Shield
3. Metal Mount
4. Steering Column
5. Pro Grip Protectors x 2
6. Back Bracket x 2
7. Suspension Column
8. Seat
9. Main Frame
10. Side Ski x 2
11. Front Ski (Tow Handle & Automatic Retracted Tow Rope Device)
12. L wrench
13. Front Ski Bolt
14. Front Nose Bolt
15. Side Ski Bolt X 2
16. Seat Screw X 4
17. Wind Shield Screw X 1 and Metal Mount Screw X 3
18. Pro Grip
19. Protectors Bolt X 4
20. Locknut (A) x 4
21. Locknut (B) x

STICKER GUIDE

INSTALLATION

Only One Step to Complete

You only need to finish step 1, as steps 2 to step 6 are previously assembled.

STEP 1 -PRO GRIP PROTECTORS ASSEMBLY

1. To assemble the Pro Grip Protectors, place the front cover in the correct position as shown, then place the 2 Bolt and back bracket. (See Fig. 1 )
2. Screw the locknut on and tighten it well using the L wrench provided. Repeat this step for other Pro Grip protector assemblies. (See Fig. 2 )
   • If you cannot match well, change the right with the left front cover and try again.
   • PREVIOUS ASSEMBLY INSTRUCTIONS
   • STEP 2 – SIDE SKI ASSEMBLY
3. Assemble the side ski by inserting the protruding steel tongue at the front of the main frame through the square hole at the top of the ski. (see Fig. 3)
4. Fasten the side ski using the side ski bolts assembly. Pass the side ski bolt from the bottom of the ski up through the frame. Then, place the locknut and tighten it securely using the nut tightener. (see Fig.4)
5. Repeat steps 3 and 4 to assemble the other side ski.
   • STEP 3 – STEERING COLUMN AND FRONT SKI ASSEMBLY
6. Insert the Steering Column to the front of the Main steel frame (See Fig. 5).
7. Insert the Suspension column to the Steering column as shown (See Fig. 5 ).
8. Insert the end of the steering column into a fitted cut away area on the Mount of the Front Ski. (See Fig. 6)
9. Align the bolt hole on the steering unit’s end and the holes on the front Ski mount wall. (See Fig. 7)
10. Insert the front ski bolt, screw the locknut on, and tighten it well using the L wrench provided. (See Fig. 7)
    • STEP4 -ADJUSTABLE SEAT ASSEMBLY
11. The seat can be mounted in one of three positions depending on the size of the rider. To begin your seat assembly, place the seat upside down with the upside-down frame on top of it as shown.
12. Select your seat position by aligning the seat assembly points with the desired assembly slots on the frame. (See Fig. 8&9)
13. Attach the seat by inserting the 4-seat Screws through the seat position slots on the Frame and tightening into the seat assembly points using the L wrench. (See Fig.1 0)
    • STEP 5 – WIND WINDOW AND FRONT NOSE ASSEMBLY
14. Insert the windshield into the front nose as shown in Fig.11 . Make sure the end of the holes on the windshield is locked into the nose.
15. Screw the windshield Screw it on and tighten it well using the L wrench provided. (See Fig. 12)
16. Attach the Metal mount to the front nose as shown and screw the three Screws on to fix it. (See Fig. 13)
17. Attached the other end of the Metal Mount to the Steering column and align the bolt hole. Insert the front Nose bolt, screw the locknut on, and tighten it well using the L wrench and Nut Tightener provided. (See Fig. 14)
    • STEP6 – USING THE AUTOMATIC RETRACTABLE TOW LEASH SYSTEM
18. The Automatic retractable tow leash system is designed to easily place and store your tow handle while riding. Release the safety buckle and take out the Tow leash handle from the Front Ski. (see Fig.15)
19. To replace the Tow leash handle, insert the Handle into the mount of the Front Ski and the Tow Rope will be Automatically Retracted into the Tow Rope Device. (see Fig. 16}
20. Always replace the tow leash handle and the locking buckle to the front ski before every use. (See Fig. 17)

IMPORTANT

• This is the only correct riding position. (see Fig. 19)
• Check all screw parts and make sure they are properly tightened and in good working condition before using the product.
• Always wear protective equipment such as a helmet, goggles, and gloves.
• Always keep the rider positioned near the front for increased control and steering. As the body is shifted closer to the back the steering and control are reduced.
• The braking system does not allow for a quick shortstop. It is solely intended as a way to gradually reduce the downhill speed.
• Be sure to learn and practice with lots of room and a shallow hill. You may progress to larger hills as you feel more confident.
• Make sure you have enough room to slow down and stop in all situations.
• Always replace the tow leash handle and the Locking Buckle to the front ski before every use.
• DO NOT tow behind any motorized vehicle or people when the rider is sitting on the product.
• If you have any questions, please contact our customer care center.

Our contact details are below:

• 416-792-6088
• customerservice@aosom.ca
• Imported by Aosom Canada Inc.
• 7270 Woodbine Avenue, Unit 307, Markham, Ontario Canada L3R 4B9
• MADE IN CHINA

Documents / Resources

| Aosom IN230500341V01 Ultimate Slope Side Snow Fun [pdf] User Manual
IN230500341V01, CA_330-027, IN230500341V01 Ultimate Slope Side Snow Fun, IN230500341V01, Ultimate Slope Side Snow Fun, Slope Side Snow Fun, Side Snow Fun, Snow Fun, Fun
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>