ASCONA PM 040-К Bed with Lifting Mechanism Relax Instruction Manual

ASCONA PM 040-К Bed with Lifting Mechanism Relax

Packing list for the bed

Legs variant depends on bed model that is represented as a samplein showroom or on the website
Complete set is shown on the label of Accessories Pack

Packing set for legs

Prior to assembly

1. Check all the parts for any damage before assembling. Any claim for them on assembled article is not accepted by Manufacturer. Package shall be kept until the end of assembly process.
2. When revealing any defect or incompleteness in the process of assembling, the package shall be kept until arepresentive of trading company arrives. Assembly and operation Instructions shall be kept during all the period of exploitation.
3. Check the parts and accessories quantity against the list. Manufacturer retains the right to make structural changes into the article, change accessories and metalware for analogous that do not affect design and do not influence on functional properties of the article. If incompleteness or any damage, mark absent part number and inform the store to replace it.
4. Maintain the assembly order given in these instructions! If the Assembly and Operation Instructions are not followed the manufacturer’s warranty obligations are removed.
5. To install sofa/armchair-bed/bed a flat floor zone shall be chosen! If the floor are curved may present deviations in the functioning of transformation mechanism of sofa/armchair-bed/bed, distortions of the article form. Any carpet presence is undesirable, because it makes transformation process difficult.
6. Perform the sofa/armchair-bed/bed assembly by two. Move all the parts gently without any jump, place them steady, escape their falls and hits!
7. Move furniture and their parts only slightly lifted. This will allow to exclude any deformation or damage.

For assembling required

Instructions for furniture assembling. Bed with lifting mechanism. Version 11 from 20.06.2024 For sidebars types: 040-К

The rails complete set depends on the bed size

.
Do not try to fold gas spring prior to being installed on the article. Gas springs folding without any mattress on the frame is prohibited and traumatic.When folding beds for the first time in some cases a light effort is required. Close the frame without fear of damaging shock absorber. If the frame is not closed with two gas springs installed, it may be connected with underweight of bought mattress it is recommended:

1. Remove one of the gas springs lower the bed frame with mattress installed on.
2. Same procedure shall be performed with second gas spring.
3. Install both of gas springs on the lifting mechanism and lower the frame. This will remove difficulties with bed folding.

To remove gas absorber:

1. Put flat screwdriver under the fixing metal staple;
2. Lift the staple up;
3. Remove the absorber fixing from the stud;
4. Repeat this from the lower part.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>