THERMOSOFT AUSTRALIA Filled Electric Radiator Instructions
- August 30, 2024
- THERMOSOFT AUSTRALIA
Table of Contents
THERMOSOFT AUSTRALIA Filled Electric Radiator
Product Specifications
- Product Name: Wall Box for Purmo Radiators
- Manufacturer: Thermosoft Australia
- Address: 159 Barkly Avenue Burnley, VIC 3121
- Website: www.thermosoftaustralia.com.au
- Email: info@thermosoftaustralia.com.au
- Contact Number : 1800 951 439
Product Usage Instructions
Wall Box Installation
- Ensure the wall box is positioned behind the radiator’s designated spot, avoiding wall studs.
- Avoid placing the box too high relative to the radiator’s size.
- If mounting brackets are on the skirting board, route the cable\ 50mm above the skirting.
- Install the wall box with plug terminals facing towards the right-hand side for easy access.
- Ensure ample space for easy connection/disconnection of the Ensto plug near a bracket.
- The Ensto box can replace an existing powerpoint and cover the cut-out neatly.
- Drill new screw holes if needed for proper fitting.
- Use a single 2.5mm cable for clean installation due to relatively small terminals.
Ensto Plug Wiring:
Follow the provided Ensto plug wiring instructions for proper setup.
Wallbox Wiring:
Refer to the wallbox wiring guide for correct wiring procedures.
Splash Cover Assembly:
Assemble the splash cover according to the provided instructions for
protection.
Splash Cover Complete:
Ensure the splash cover is fully assembled and securely in place for
safety.
If you have any questions or need further assistance, contact us at 1800 951 439 or via email at info@thermosoftaustralia.com.au.
Wall Box Wiring & Installation Notes
Please find enclosed the wall boxes designed for the installation of Purmo radiators. Here are some installation tips for optimal setup:
- Typically, install the wall boxes behind the radiator’s designated position, usually centered but clear of any wall studs used for the heater’s mounting brackets.
- Avoid placing the Ensto box too high in relation to the radiator’s size.
- If the heater brackets are to be mounted on the skirting board, route the cable through the wall approximately 50mm above the skirting.
- Install the wall box with the plug terminals facing towards the right-hand side.
- Pay attention to the placement of the heater mounting bracket, ensuring there’s ample room for the Ensto plug to be easily connected or disconnected when installed close to a bracket.
- The Ensto box can serve as a replacement for an existing powerpoint, as it will neatly cover the cut-out. You may need to drill new screw holes into the wall box to fit it properly.
- Given that the terminals are relatively small, it’s advisable to route a single 2.5mm cable into the box for a clean installation.
Should you have any questions or require further assistance, please don’t hesitate to contact us at 1800 951 439 or via email at info@thermosoftaustralia.com.au
USING INSTRUCTION
MORE INFORMATION
Thermosoft Australia
159 Barkly Avenue Burnley, VIC 3121
www.thermosoftaustralia.com.au
mail:
info@thermosoftaustralia.com.au
Call: 1800 951 439
FAQ
- Q: Can the Ensto box be used as a replacement for an existing powerpoint?
- A: Yes, the Ensto box can serve as a replacement for an existing powerpoint and cover the cut-out neatly.
- Q: What cable size should be routed into the wall box for installation?
- A: It is advisable to route a single 2.5mm cable into the box for a clean installation due to relatively small terminals.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>