twelve south PlugBug 120W USB iPhone and iPad Add On and International Charger User Guide

: August 29, 2024
: twelve south

Table of Contents

twelve south PlugBug 120W USB iPhone and iPad Add On and International
Introduction
What’s in the Box
Open the Battery Door and pull the Tab
Turn on PlugBug
Using Apple Find My
FCC Statement
Read User Manual Online (PDF format)
Download This Manual (PDF format)

twelve south PlugBug 120W USB iPhone and iPad Add On and International

Charger

Introduction

The following instructions will be printed on a marking label or user manual of the gift box or included product or similar means in English and French:
The socket outlet shall be installed near the equipment and shall be easily accessible.
Button battery replacement steps:
First press the battery compartment clip to remove the rear cover, then use a screwdriver to unscrew two metal screws on the middle partition and open the middle partition to replace the battery.

Scan for Visual Start guide

What’s in the Box

Open the Battery Door and pull the Tab

Attaching and Removing Plug Adapter

Turn on PlugBug

Press and hold the button for 3 seconds, and the device will beep and turn on. Double-press the button, A chime will sound.
Note: To turn off, double-click the device first, then quickly press the button 5 times within 2 seconds, a long beep will sound.

Using Apple Find My

Please reference the PlugBug Find My Setup guide

Reset PlugBug

After successfully removing the PlugBug from the Find My app, quickly press the button twice. A chime will sound. then, Press and hold the button for about 5 seconds after the second confirmation chime sound, Press and Hold again for another 3 seconds until you hear a prompt sound to reset the device.
The PlugBug is now reset and ready to be paired with a new Apple ID.

Change the Battery

Dynamic Power Allocation

Designed by Twelve South. Made in Vietnam

WARNING

INGESTION HAZARD: This product contains a button cell or coin battery.
DEATH or serious injury can occur if ingested.
A swalowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours.
KEEP new and used batterins OUT OF REACH of CHIDREN Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.

To comply with the published safety standards, the following must be observed when using this adaptor.

For information technology equipment and office equipment use only.
Do not use if the outer enclosure or plug is damaged.
Do not exceed the manufacturer’s specifications when in use.
Do not attempt to disassemble or modify the charger; doing so may result in injury or damage.
Ensure the charger is connected to a compatible power source and the voltage matches the device’s requirements.
Always unplug the power supply when not in use.
Only use indoors in a dry environment.
Do not expose the power supply to dripping or splashing water.
Do not place objects filled with liquids, such as vases, etc. on or near the power supply.
Do not cover the charger during operation or use it near heat sources such as radiators or stoves.
Store the charger in a location inaccessible to children to prevent accidental ingestion or tampering.
This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the power supply by a person responsible for their safety.
Maximum ambient temperature: 25°C / 77° F.
The main plug is used as the disconnect device. The disconnect device shall be readily operable.
Before charging, ensure there are no foreign objects, such as metal objects or liquids, obstructing the charger’s ports. Inserting foreign objects may damage the charger or connected devices.
Do not expose the charger to flammable or harsh chemicals or vapors.
Do not use the charger when either you, the vehicle or the charger is exposed to severe rain, snow, electrical storm or other inclement weather.
When transporting the charger, handle it with care to prevent damage to any of its components. Do not subject the charger to strong force or impact. Do not twist, tangle, drag or step on the charger or any of its components.
Protect the charger from moisture, water, and foreign objects at all times. If any exist or appear to have corroded or damaged the charger, do not use the charger.
Do not use this device with an extension cord or an adapter.
Ensure that the charger’s charging cable does not obstruct pedestrians or other objects.
Connected only to a properly grounded outlet.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.
The device shall be used in such a manner that the potential for human contact normal operation is minimized.
This transmitter must be installed to provide a separation distance of at least 20 cm from all persons.
Conforms to UL 62368-1 and Certified to CSA C22.2 No. 62368-1:19.
Twelve South, Inc. hereby declares that this wireless device complies with the Directive.
Remove and immediately recycle or dispose of used batteries according to local regulations and keep them away from children. Do NOT dispose of batteries in household trash or incinerate them.
Even used batteries may cause severe injury or death.
Call a local poison control center for treatment information.
Battery type: CR2032H.
Nominal battery voltage: 3.0V.
Non-rechargeable batteries are not to be recharged.
Do not force discharge, recharge, disassemble, heat above 80°C or incinerate. Doing so may result in injury due to venting, leakage or explosion resulting in chemical burns.
Ensure the batteries are installed correctly according to polarity+and-).
Remove and immediately recycle or dispose of batteries from equipment not used for an extended time according to local regulations.
Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the battenes, and keep them away from children.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

ISED Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the device.

The digital apparatus complies with Canadian CAN ICES-3 (B) and NMB-3(B).

This equipment complies with Canada’s radiation exposure limits set forth for an uncontrolled environment.

The device has been evaluated to meet general RF exposure requirements. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.

Have questions?