FISHER PAYKEL ADDD60D Integrated Single DishDrawer Dishwasher Installation Guide
- June 3, 2024
- Fisher & Paykel
Table of Contents
FISHER PAYKEL ADDD60D Integrated Single DishDrawer Dishwasher
SAFETY & WARNINGS
WARNING!
Electric Shock Hazard
Failure to follow this advice may result in electrical shock or death.
- Read and follow the safety and warnings before operating this appliance.
Cut Hazard
Failure to use caution could result in injury.
- Ensure a 2mm minimum ventilation gap below the door is maintained.
- Ensure all packaging is removed and disposed of responsibly.
- Ensure the Knock-To-Pause module is oriented correctly before attaching.
COMPONENTS REQUIRED
DOOR PANEL INSTALLATION
-
Remove both side pins with pliers and carefully pull the panel bracket down and out slightly.
-
Unplug knock-to-pause module from the controller and remove the earth wire from the bracket.
-
Remove the Knock-to-Pause module from the back of the bracket.
-
Install the handle to the panel following the installation guidance available for your handle kit.
-
Attach the Knock-to-Pause module to the panel as shown. Ensure the module is correctly oriented and is not in contact with the brackets before securing.
-
Reconnect the Knock-to-Pause module to the UI 1 slot on the wash controller as shown.
-
Reconnect the Earth wire to the panel bracket.
Warning: Failure to reconnect the Earth wire may result in electrical shock or death. -
Carefully fit the panels onto the product. Re-insert both side pins to secure panels in place.
-
Insert a crosshead driver into the hole above each side pin and rotate to adjust the panel alignment. There is a maximum travel distance of ± 1/16”(2mm). Repeat for both sides if required.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>