SANTEC 9550KL-TM Klassica Collection Roman Tub Filler Installation Guide
- August 25, 2024
- SANTEC
Table of Contents
SANTEC 9550KL-TM Klassica Collection Roman Tub Filler
Important Santec reserves the right to request additional documents before servicing warranty requests.
Spout
Rough Installation For Spout
Hole size for the Spout and handle trim is minimum of 1-1/4” and maximum of
1-1/2”.
Turn off HOT and COLD supply lines before beginning installation.
Remove tee connector and spout mounting hardware from spout shank.
Find the “front here” mark, which is marked on the base, and make sure that it
is facing frontward. Slip spout shank through deck top and reattach the spout
mounting hardware until secure.
Wipe away excess silicone with paper towel.
Wrap the bottom threads with plumber’s tape and thread the tee connector back
onto spout shank.
Spout Trim Installation
From the top of the deck, slip the spout with the flange washer onto the quick
connect shank top.
Align the spout and tighten the set screw with the Allen key provided.
Note : If trim comes later than the roughs, please keep the shank protector on the spout shank at all times to avoid damages to the unit.
Handle
Rough Installation For Handle
- NOTE : Hot valve “Red” mounted to left side. Cold valve “Blue” to be mounted on right side.
- Remove the top lock nut and top lock nut washer from the valve body.
- Apply a ring of silicone around the handle hole on top of the deck. Do not use plumber’s putty, which can damage finish.
- While tightening the valve body into place make sure to keep the position of the valve body outlet pointed toward the tee connector.
- Slip the valve body into the proper handle hole from underneath the tub. Thread the top lock nut and top lock nut washer back onto the valve body and tighten down securely.
- From underneath, tighten the brass lock nut securely.
Handle Trim Installation
NOTE : In the off positions the “Hot” handle lever (left) should be in the “9 o’clock” position, and the “Cold” handle lever (right) should be in the “3 o’clock” position. In the “on” positions the levers should both turn towards you, not away from you.
Fit the handle down onto the installed valve body making sure that the handle
levers are in a parallel line with the spout.
Turn the trim body clockwise onto the valve body until tightened down
securely.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>