FUJIFILM BL00005278-100 Fujinon Lens Owner’s Manual

: August 24, 2024
: Fujifilm

FUJIFILM BL00005278-100 Fujinon Lens

OWNER’S MANUAL

For Your Safety

Be sure to read these notes before use

Safety Notes

Thank you for your purchase of this product.
For repair, inspection, and internal testing, contact your Fujifilm dealer.

Make sure that you use the lens correctly.
Read these safety notes and the camera Owner’s Manual carefully before use.
After reading these safety notes, store them in a safe place.

About the Icons

The icons shown below are used in this document to indicate the severity of the injury or damage that can result if the information indicated by the icon is ignored and the product is used incorrectly as a result.

WARNING

This icon indicates that death or serious injury can result if the information is ignored.

CAUTION

This icon indicates that personal injury or material damage can result if the information is ignored.

The icons shown below are used to indicate the nature of the instructions which are to be observed.

Triangular icons tell you that this & information requires attention (“Important”).
Circular icons with a diagonal bar (S) tell you that the action indicated is prohibited (“Prohibited”).
Filled circles with an exclamation mark indicate an action that must be performed (“Required”).

WARNING

Do not us, in the bathroom or sbower. Do not immerse in or expose to water. Failure to observe this precaution can cause a fire or electric shock.

Do not disassemble. Failure to observe this precaution can cause fire, electric shock, or injury due to product malfunction.

Do not touch internal parts. Should the case break open as the result of a fall or other accident, do not touch the exposed parts. Failure to observe this precaution could result 1n electric shock or in injury from touching the damaged parts.

Remove the camera battery immediately, taking care to avoid injury or electric shock, and take the product to the point of purchase for consultation.

WARNING

Do not f!lace on unstable surfaces.
The product may fall, causing injury.
Do not view the sun through the lens or camera viewfinders. Failure to observe this precaution can cause permanent visual impairment.

CAUTION

Do not use or store in locations that are exf!osed to steam, or smoke or are veu humid or extreme dusty. Failure to obser ve this precaution can cause fire or electric shock.
Do not leave in direct sunlight or in locations subiect to verry high temperatures, such as in a closed vehicle on a sunny day. Failure to observe this precaution can cause fire.

CAUTION

Keep out of the reach of small children. This product could cause injury in the hands of a child.

Do not handle with wet hands. • Failure to observe this precau-tion can cause electric shock.

Keep the use out of the frame when shooting backlit sub’es. • Sunlight focused into the camera when the sun is in or close to the frame can cause fire or burns.

When the product is not in use replace the lens caps and store • out of diredsunli lqA. Sunlight focused by the lens can cause fire or burn.

Do not carry the camera or lens while they are attached to a tripod. The product can fall or strike other objects, caus-ing injury.

CUSTOMERS IN THE USA

Tested To Comply With FCC Standards

FOR OFFICE AND HOME USER

FCC Statement: This device compiles with Part 15 of the FCC Rule, Operation is subject to the follow-mg two condftions: (1) This device may not cause harmful Interference, and (2) this devke must ac-cent any Interference received. Including Interfer-ence that may cause undesired operafion.

CAUTION : This equipment has been tested and found to comply with the limits fora Class B digital device, pursuant to Part 15 of the FCC Rule.

These limits are designed to provide reasonable protec-tion against harmful interference Ina residential in-stallation. This equipment generates, uses, and can radiate radio frequency energy and, snot Installed and used in accordance with the instructions, may cause harmful Interference to radio communica-tion, However, there is no guarantee that inter-ference Will not occur Ina particular Installation. If this equipment dooes cause harmful interference to radio or televlsbn recent., which can be de-termined by turning the equipment off and on, the user Is encouraged Is try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a dr-cult different from that to which the receiver Is connected
Consult the dealer or an experienced radio/IV technician for help.
You are cautioned that any changes or modifi-cations not expressly approved in this manual could void the user’s authority to operate the equipment

Notes on the Grant: To comply with Part 15 of the FCC Rules, this product must be used with a FujIfilm-specified ferrite-core AN cable, USB cable, and DC supply cord.

CAN ICES-003 (B)/NMB-003(8)
CAUTION : This Class B digital apparatus complies with Canadian ICES-003.

IMPORTANT SAFETY INSTRUCTIONS

Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water (excluding waterproof pro ducts).
Clean only with a dry cloth.
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
Do not install near any heat sources such as radiators, heat registers , stoves, or other apparatus (including amplifiers) that produce heat.
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
Only use attachments/accessories specified by the manufacturer.
Unplug this apparatus during lightning storms or when unused for long periods of time.
Refer all servicing to qualified service personal. Servicing Is required when the apparatus has been damaged In any way, such as power supply cord or plug is damaged, l iquid has been spilled or objects have fallen into the appa ratus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

Product Care

When using a lens hood, do not pick up or hold the camera using only the hood.
Keep the lens signal contacts clean.
Use a blower to remove dust and lint from the glass surfaces of the lens or filter. To remove smudges and fingerprints, apply a small amount of lens cleaner to a soft, clean cotton cloth or lens-cleaning tissue and clean from the center outwards using a circular motion, taking care not to leave smears or touch the glass with your fingers.
Never use organic solvents such as paint thinner or benzene to clean the lens.
Attach the front and rear caps when the lens is not in use.
Store the lens and filter in cool, dry locations to prevent mold and rust. Do not store in direct sunlight or with naphtha or camphor moth balls.
Keep the lens dry. Rusting can cause irrepara-ble damage. Wipe off rain and water droplets.
Leaving the lens in extremely hot locations could cause damage or warping.

PARTS OF THE LENS

XF76-50mmF2.8-4.8 R LM WR

1. Lens hood
2. Mounting marks
3. Focus ring
4. Zoom ring
5. Aperture ring
6. Mounting marks (focal length)
7. Aperture mode switch
8. Lens signal contacts
9. Front lens cap
10. Rear lens cap

! The lens mount includes a rubber ring to ensure that the lens remains dust- and splash-proof. The ring can be replaced for a fee at any Fujifilm service center.

Attaching the Lens

See the camera manual for information on attaching and removing lenses.

1. This product is for use exclusively with the FUJIFILM X mount.
It is not compatible with the G mount or with X mount film cameras.

Removing the Caps

Remove the caps as shown.

Attaching the Hood

When attached, lens hoods reduce glare and protect the front lens element.

Supplied Accessories

Front lens cap
Rear lens cap
Lens hood
Lens wrapping cloth

Zoom

Rotate the zoom ring left to zoom out, re ducing magnification and increasing the area visible in the frame. Rotate the ring right to zoom in, increasing magnification so that the subject occupies more of the frame.

! Using the zoom ring while the lens is wet makes it easier for water to find its way inside the lens. Wipe any water from the lens before using the zoom ring.

Aperture

For auto aperture control, slide the aperture mode switch to A.

To adjust aperture manually, slide the switch to and rotate the aperture ring. Rotate the ring left for wider apertures (lower f-numbers),

SPECIFICATIONS

! Improvements may result in unannounced changes to specifications and appearance.
! Owing to how this lens is constructed, the “Distance indicator” displayed by the camera may in some cases differ from the actual focus dis tance. Use the “Distance indicator” as a gu ide only.

This lens uses linear motors to ensure fast and accurate auto focus while maintaining the highest image quality. When the camera is turned

DISPOSAL OF ELECTRIC AND ELECTRONIC EQUIPMENT

In the European Union, Norway, Iceland and Liechtenstein: This symbol on the product, or in the manual and in the warranty, and/or on its packaging indicates that this product shall not be treated as household waste. It should be taken to an applaince collection point for the recycling of electrical and electronic equipment.

By ensuring this product is disposed of correctly, you will help prevent potential negative conse quences to the environment and human health,
which could otherwise be caused by inappropriate waste handling of this product.

The recycling of materials will help to conserve natural resources. For more detailed information about recycl ing this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

In Countries Outside the European Union, Norway,
Iceland and Liechtenstein: If you wish to discard th is product, including the batteries or accumulators,
please contact your local authorities and ask for the correct way of disposal.

U.K. Importer:
FUJIFILM UK Limited
Fujifilm House, Whitbread Way, Bedford,
Bedfordshire, MK42 OZE, United Kingdom
EU Importer:
FUJIFILM Electronic Imaging Europe GmbH
Fujistrasse 1 47533 Kleve, Germany
Australian RCM

Before Using This Product

The lens may not perform as expected and some features may not be available with outdated lens or camera firmware. Be sure to update the lens and camera firmware to the latest versions. Instructions on viewing firmware version information and updating firmware are available from the following website:

https://fujifilm-x.com/support/download/firmware/

If you do not have access to a computer, support is available from the local distributor listed in the “FUJIFILM Worldwide Network” material provided with your camera.

Specifications:

Product Name: FUJINON LENS XF16-50mmF2.8-4.8 R LM WR
Focal Length: 16-50mm (35mm equivalent: 24-76mm)
Maximum Aperture: F2.8-4.8
Minimum Aperture: F22
Lens Construction: 9 elements in 11 groups, including 3 aspherical and 3 ED elements
Minimum Focus Distance: 0.24m
Filter Size: 58mm
Dimensions: 65mm x 71.4mm
Weight: 240g